Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › FRONT BUMPER › 2020.07–2020.09
RM36W0E _59 Vehicle Exterior _088302 EXTERIOR PANELS / TRIM _0421038 FRONT BUMPER A

EXTERIOR PANELS / TRIM  FRONT BUMPER  INSTALLATION  


PROCEDURE

Hide 1.INSTALL FRONT BUMPER ASSEMBLY

a.

Install the grommet.

HINT:

Use the same procedure for the RH side and LH side.



b.

Temporarily install the front bumper assembly.


c.

Install the 2 clips and 2 bolts.


d.

Connect the connector.


e.

Pull back the side of the front bumper assembly.

B577668C01
0.292,0.604 0.5,0.802 0.208,0.198 10 true *A 0.302,1.667 0.51,1.844 0.208,0.177 10 true *B 0.313,2.74 0.51,2.906 0.198,0.167 10 true *C 5.698,0.594 5.906,0.792 0.208,0.198 10 true *A 5.698,1.656 5.906,1.833 0.208,0.177 10 true *B 5.708,2.729 5.906,2.896 0.198,0.167 10 true *C 1.135,1.323 1.271,1.49 0.135,0.167 10 true A
*A w/o Fog Light *B w/ LED Type Fog Light
*C w/ Bulb Type Fog Light - -


NOTICE:

Do not apply excessive force when pulling back the front bumper assembly.



f.

w/o Fog Light:

i.

Connect the connectors and engage the clamp.


ii.

for TMC Made:

1. Connect the connector A.



g.

w/ LED Type Fog Light:

i.

Connect the connectors and engage the clamp.



h.

w/ Bulb Type Fog Light:

i.

Connect the connectors and engage the clamp.



i.
B577634C01
0,0 0,0 false
V113147

Install in this Direction


Engage the claws as shown in the illustration.

HINT:

Use the same procedure for the RH side and LH side.



j.

Install the 6 screws.


Hide 47749F 2.INSTALL PIN HOLD CLIP

a.

Engage the claw to install the pin hold clip.

HINT:

Use the same procedure for the RH side and LH side.



Hide 4.ADJUST MILLIMETER WAVE RADAR SENSOR (w/ Toyota Safety Sense 2)

a.

When the millimeter wave radar sensor assembly is replaced with a new one, adjustment of the radar sensor beam axis must be performed.



Hide 5.PERFORM CALIBRATION (w/ Parking Support Brake System)