Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
65632D
1.REMOVE REAR WHEEL HOUSE FRONT PLATE (w/ Engine Under Cover Assembly)
75852
2.REMOVE ROCKER PANEL MOULDING (for TMC Made)
Apply protective tape around the rocker panel moulding and doors as shown in the illustration.
|
Protective Tape | - | - |
Remove the 6 clips.
Remove the 6 screws.
Remove the 4 grommets.
Disengage the clips to remove the rocker panel moulding as shown in the illustration.
|
Remove in this Direction | - | - |
75852
3.REMOVE ROCKER PANEL MOULDING (for TMMF Made)
Apply protective tape around the rocker panel moulding and doors as shown in the illustration.
|
Protective Tape | - | - |
Remove the 6 clips.
w/ o Engine Under Cover Assembly:
Remove the clip and 2 screws.
Remove the 5 screws.
Remove the 3 grommets.
Disengage the clips to remove the rocker panel moulding as shown in the illustration.
|
Remove in this Direction | - | - |