CHECK AIR CONDITIONING AMPLIFIER ASSEMBLY (for Automatic Air Conditioning System HV Model)
Disconnect the H24 air conditioning amplifier assembly connector.
Measure the voltage and resistance according to the value(s) in the table below.
| Terminal No.
(Symbol) |
Terminal Description | Condition | Specified Condition |
|---|---|---|---|
| H24-5 (B) - H24-17 (GND) | Power source | Ignition switch off | 11 to 14 V |
| H24-6 (IG+) - H24-17 (GND) | Power source (IG) | Ignition switch ON | 11 to 14 V |
| Ignition switch off | Below 1 V | ||
| H24-17 (GND) - Body ground | Ground for main power supply | Always | Below 1 Ω |
| H24-26(SHIN) - H24-17(GND) | Driver side seat heater switch HI operation signal | ·
Ignition switch ON ·
Seat heater switch off or on (LO) |
Below 1 V |
·
Ignition switch ON ·
Seat heater switch on (HI) |
11 to 14 V |
CHECK POWER DISTRIBUTION BOX ASSEMBLY
Remove the power distribution box assembly.
for LHD:
Click herePower Source / Network>POWER DISTRIBUTION>MAIN BODY ECU (for LHD)>REMOVAL
for RHD:
Click herePower Source / Network>POWER DISTRIBUTION>MAIN BODY ECU (for RHD)>REMOVAL
Reconnect the power distribution box assembly connectors.
Measure the voltage and resistance according to the value(s) in the table below.
| Terminal No.
(Symbol) |
Terminal Description | Condition | Specified Condition |
|---|---|---|---|
| 4G-1 - Body ground | Power source | Ignition switch off | 11 to 14 V |
| 4C-25 - Body ground | Ground | Always | Below 1 Ω |
| 4C-39 - Body ground | Power source output (seat heater LH) | Ignition switch off | Below 1 Ω |
| Ignition switch ON | 11 to 14 V | ||
| 4C-40 - Body ground | Power source output (seat heater RH) | Ignition switch off | Below 1 Ω |
| Ignition switch ON | 11 to 14 V |