Home › Vehicle Interior › POWER OUTLETS (INT) › WIRELESS CHARGING SYSTEM › from 2020.07
RM36W0E _58 Vehicle Interior _088337 POWER OUTLETS (INT) _0433480 WIRELESS CHARGING SYSTEM J

POWER OUTLETS (INT)  WIRELESS CHARGING SYSTEM  Wireless Charger Illumination Circuit  


DESCRIPTION

When the taillight is on, this circuit sends an illumination signal to the mobile wireless charger cradle assembly.

WIRING DIAGRAM

E445963E01
1,0.917 2.271,1.198 1.271,0.281 10 false from PANEL Relay 4.813,0.927 5.229,1.104 0.417,0.177 10 false TAIL 4.542,0.844 4.771,1.021 0.229,0.177 10 false 10 4.542,1.448 6.156,1.823 1.615,0.375 10 false Mobile Wireless Charger Cradle Assembly 4.552,1.292 4.927,1.469 0.375,0.177 10 false H86

CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuse for circuits related to this system before performing the following procedure.


PROCEDURE

1.CHECK HARNESS AND CONNECTOR (ILLUMINATION SIGNAL)
a.

Disconnect the H86 mobile wireless charger cradle assembly connector.


b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
H86-10 (TAIL) - Body ground Light control switch in off position Below 1 V
H86-10 (TAIL) - Body ground Ignition switch off, light control switch in tail or head position 11 to 14 V



Result:
Proceed to
OK
NG



OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR