55908A
1.REMOVE AIR INLET DAMPER CONTROL CABLE SUB-ASSEMBLY (for Manual Air Conditioning System)
for Single Layer Type:
Disengage the claws to remove the air inlet damper control cable sub-assembly.
87151J
2.REMOVE NO. 1 DAMPER PLATE (for Automatic Air Conditioning System)
Disengage the claw to remove the No. 1 damper plate.
87130K
3.INSTALL NO. 1 BLOWER DAMPER SERVO SUB-ASSEMBLY (for Automatic Air Conditioning System)
Remove the 2 screws and No. 1 blower damper servo sub-assembly.
87103B
4.REMOVE BLOWER MOTOR WITH FAN SUB-ASSEMBLY
Remove the 3 screws and blower motor with fan sub-assembly.
88899M
5.REMOVE AIR FILTER COVER PLATE
Disengage the claw and guides to remove the air filter cover plate.
87139C
6.REMOVE CLEAN AIR FILTER
Remove the air filter sub-assembly.
87138C
7.REMOVE BLOWER RESISTOR (for Manual Air Conditioning System)
for Single Layer Type:
Remove the 2 screws and blower resistor.
for Double Layer Type:
|
Remove in this Direction |
Remove the screw and blower resistor as shown in the illustration.