84520
1.INSPECT CLUTCH START SWITCH ASSEMBLY
Check the resistance.
| *a | Component without harness connected
(Clutch Start Switch Assembly) |
| *b | 11.65 to 12.35 mm (0.459 to 0.486 in.) |
| *c | On |
| *d | Off |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A64-1 (L) - A64-2 (B) | On (Pushed in) | Below 1 Ω |
| A64-1 (L) - A64-2 (B) | Off (Released) | 10 kΩ or higher |
If the result is not as specified, replace the clutch start switch assembly.
88280A
2.INSPECT CLUTCH SWITCH ASSEMBLY
Check the resistance.
| *a | Component without harness connected
(Clutch Switch Assembly) |
| *b | 6.5 to 7.5 mm (0.256 to 0.295 in.) |
| *c | On |
| *d | Off |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A65-1 (CL+) - A65-2 (CL-) | On (Pushed in) | Below 1 Ω |
| A65-1 (CL+) - A65-2 (CL-) | Off (Released) | 10 kΩ or higher |
If the result is not as specified, replace the clutch switch assembly.