Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › REAR VIEW MONITOR SYSTEM › 2020.07–2021.04
RM36W0E _56 Audio / Visual / Telematics _088657 PARK ASSIST / MONITORING _0434307 REAR VIEW MONITOR SYSTEM U

PARK ASSIST / MONITORING  REAR VIEW MONITOR SYSTEM  TERMINALS OF ECU  


CHECK RADIO AND DISPLAY RECEIVER ASSEMBLY


E439677E02
1.406,0.333 1.823,0.583 0.417,0.25 0.906,2.219 1.323,2.469 0.417,0.25 5.75,2.167 6.167,2.417 0.417,0.25 2.469,2.219 2.885,2.469 0.417,0.25 3.354,0.333 3.771,0.583 0.417,0.25 5.25,0.344 5.667,0.594 0.417,0.25 4.698,2.219 5.115,2.469 0.417,0.25 3.604,2.219 4.021,2.469 0.417,0.25 1.479,0.375 1.792,0.573 0.313,0.198 10 false H79 3.438,0.365 3.75,0.563 0.313,0.198 10 false H80 0.979,2.26 1.292,2.458 0.313,0.198 10 false H83 5.865,2.198 6.177,2.396 0.313,0.198 10 false RA 2.521,2.26 3.135,2.458 0.615,0.198 10 false H124 5.323,0.385 5.635,0.583 0.313,0.198 10 false H81 3.719,2.26 4.333,2.458 0.615,0.198 10 false GP 4.802,2.271 5.417,2.469 0.615,0.198 10 false DB

a.

Disconnect the H79 and H80 radio and display receiver assembly connectors.


b.

Measure the voltage and resistance according to the value(s) in the table below.

Terminal No. (Symbol) Terminal Description Condition Specified Condition

*1: w/o Stop and Start System

*2: w/ Stop and Start System

H80-19 (IG) - Body ground Power source (IG) Ignition switch off Below 1 V
Ignition switch ON 11 to 14 V
H79-15 (ACC1) - Body ground Power source (ACC) Ignition switch off Below 1 V
Ignition switch ACC 11 to 14 V*1
10.5 to 16 V*2
H79-4 (+B1) - Body ground Power source (+B) Ignition switch off 11 to 14 V*1
10.5 to 16 V*2
H79-1 (GND1) - Body ground Ground Always Below 1 Ω


c.

Reconnect the H79 and H80 radio and display receiver assembly connectors.


d.

Measure the voltage and check for waveform according to the value(s) in the table below.

Terminal No. (Symbol) Terminal Description Condition Specified Condition
H79-28 (REV) - Body ground Reverse signal Ignition switch ON, shift lever in R 11 to 14 V
Ignition switch ON, shift lever not in R Below 1 V
H80-28 (V+) - H79-29 (V-) Display signal Ignition switch ON, shift lever in R Pulse generation (See waveform 1)
Ignition switch ON, shift lever in R, screen blacked out by covering camera lens Pulse generation (See waveform 2)
H80-30 (CA+) - H79-27 (CGND) Power source Ignition switch ACC 5.5 to 7.05 V
H80-27 (CGND) - Body ground Camera ground Always Below 1 Ω
H80-26 (CSLD) - Body ground Shield ground Always Below 1 Ω


e.
E159949N05
0.196,1.018 0.531,1.162 0.335,0.144 10 GND

Using an oscilloscope, check waveform 1.

Measurement Condition
Item Content
Terminal No. (Symbol) H80-28 (V+) - H80-29 (V-)
Tool Setting 200 mV/DIV., 50 μsec./DIV.
Condition Ignition switch ON, shift lever in R


f.
E164781N04
0.275,1.002 0.612,1.146 0.337,0.145 10 GND

Using an oscilloscope, check waveform 2.

Measurement Condition
Item Content
Terminal No. (Symbol) H80-28 (V+) - H80-29 (V-)
Tool Setting 200 mV/DIV., 50 μsec./DIV.
Condition Ignition switch ON, shift lever in R, screen blacked out by covering camera lens