Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › THEFT DETERRENT SYSTEM › 2020.07–2020.09
RM36W0E _58 Vehicle Interior _087476 THEFT DETERRENT / KEYLESS ENTRY _0434686 THEFT DETERRENT SYSTEM D

THEFT DETERRENT / KEYLESS ENTRY  THEFT DETERRENT SYSTEM  SYSTEM DESCRIPTION  


OUTLINE OF THEFT DETERRENT SYSTEM


·

The theft deterrent system can be set by locking the doors using any of the following operations:

-

Entry lock operation*1

-

Wireless lock operation

*1: w/ Entry and Start System



·

In the armed state, the alarm function will be activated if one of the following conditions is met:

-

Any of the doors are unlocked.

-

Any of the doors or the engine hood is opened.


·

In the alarm sounding state, the system blinks the turn signal lights. At the same time, the system sounds the vehicle horns and security horn assembly to deter break-in and theft as well as to warn people around the vehicle.

·

The theft deterrent system can be canceled by unlocking the doors using the following operation:

-

Entry unlock operation*1

-

Wireless unlock operation

-

Key linked lock operation

*1: w/ Entry and Start System



·

The theft deterrent system has an active arming mode. There are 4 states in this mode: a disarmed state, an arming preparation state, an armed state and an alarm sounding state.


a.

Disarmed state:

·

The alarm function is not operating.

·

The theft deterrent system is not operating.



b.

Arming preparation state:

·

The time until the system goes into the armed state.

·

The theft deterrent system is not operating.



c.

Armed state:

·

The theft deterrent system is operating.



d.

Alarm sounding state:

·

The alarm function is operating.


Alarm time:

Approximately 27.5 seconds


Alarm Methods
Alarm Method Turn Signal Lights Blinking
Vehicle Horns Sounding
(approximately 0.4-second cycles)
Security Horn Assembly Sounding
(approximately 0.4-second cycles)



FUNCTION OF MAIN COMPONENTS


Component Function
Security indicator light Informs driver of theft deterrent system status.
Security horn assembly Sounds when attempted break-in or theft is detected.
Turn signal lights Blink when attempted break-in or theft is detected.
Vehicle horns Sound when attempted break-in or theft is detected.
·

Front door courtesy light switch assembly LH/RH

·

Rear door courtesy light switch assembly LH/RH


Detects door status (open or closed).
Door unlock detection switch Detects door status (locked or unlocked).
Hood lock assembly (engine hood courtesy switch) Detects engine hood status (open or closed).
Back door lock assembly (back door courtesy light switch) Detects back door status (open or closed).
Certification ECU (smart key ECU assembly)*1
·

Receives wireless door lock/unlock signal.

·

Receives entry door lock/unlock signal.


Main body ECU (multiplex network body ECU)*2 Receives wireless door lock/unlock signal.

*1: w/ Entry and Start System

*2: w/o Entry and Start System



ACTIVE ARMING MODE


a.

Active arming mode:

This system operates as described in the diagram below when one of the items for each condition is met.

HINT:

The term "all doors" used in this section refers to the driver door, front passenger door, rear door LH and rear door RH and back door.



E446734E01
3.021,0.656 4.156,0.833 1.135,0.177 10 false Disarmed State 0.542,1.969 1.146,2.896 0.604,0.927 10 false All doors and the engine hood is closed. 3.865,1.958 4.885,2.313 1.021,0.354 10 false The engine hood is opened. 1.438,1.146 2.208,1.344 0.771,0.198 10 false [1] 2.135,2.26 2.906,2.458 0.771,0.198 10 false [3] 1.448,3.198 2.219,3.396 0.771,0.198 10 false [5] 4.01,2.438 4.781,2.635 0.771,0.198 10 false [6] 2.99,3.042 3.76,3.24 0.771,0.198 10 false [4] 5.583,1.135 6.354,1.333 0.771,0.198 10 false [2] 4.844,2.25 5.615,2.448 0.771,0.198 10 false [3] 6.26,6.302 7.031,6.5 0.771,0.198 10 false [12] 5.563,5.26 6.333,5.458 0.771,0.198 10 false [10] 4.781,6.385 5.552,6.583 0.771,0.198 10 false [11] 4.417,5.26 5.188,5.458 0.771,0.198 10 false [7] 3.938,4.5 4.708,4.698 0.771,0.198 10 false [12] 2.167,6.375 2.938,6.573 0.771,0.198 10 false [9] 1.438,5.26 2.208,5.458 0.771,0.198 10 false [8] 0.875,4.813 1.646,5.01 0.771,0.198 10 false [7] 4.281,2.708 6.292,2.896 2.01,0.188 10 false Arming Preparation State (2) 1.49,4.771 2.542,5 1.052,0.229 10 false Armed State (1) 2.99,6.823 4.479,7.115 1.49,0.292 10 false Alarm Sounding State 5.552,3.188 6.323,3.385 0.771,0.198 10 false [5] 0.854,6.854 1.625,7.052 0.771,0.198 10 false [7] 6.229,4.177 7,4.375 0.771,0.198 10 false [12] 6.229,2.115 7,2.313 0.771,0.198 10 false [12] 1.146,2.698 3.156,2.885 2.01,0.188 10 false Arming Preparation State (1) 4.656,4.76 5.708,4.99 1.052,0.229 10 false Armed State (2)

w/ Entry and Start System
Condition Item
Condition [1] In disarmed state, when the ignition switch is off, the system state is switched if the following condition is met:
·

With all doors and the engine hood closed, all doors are locked by wireless operation or entry operation.


Condition [2] In disarmed state, when the ignition switch is off, the system state is switched if the following condition is met:
·

With all doors and the engine hood opened, all doors are locked by wireless operation or entry operation.


Condition [3] One of the following conditions is met:
·

All doors are unlocked by wireless operation, entry operation or key linked lock operation.

·

Any door is unlocked.

·

Any door is opened.

·

The power switch is pushed. (for HV Model)

·

The engine switch is pushed. (for Gasoline Model)

·

The ignition switch is turned to ACC or ON.

·

The auxiliary battery is reconnected.


Condition [4]
·

The engine hood is opened.


Condition [5]
·

Allow approximately 30 seconds to elapse.


Condition [6]
·

The engine hood is closed.


Condition [7] One of the following conditions is met:
·

for Gasoline Model:

The ignition switch is turned to ON and the engine is running at 550 rpm for 2 seconds or more.

·

for HV Model:

The ignition switch is turned to ON (READY).

·

All doors are unlocked by wireless operation, entry operation or key linked lock operation.


Condition [8] One of the following conditions is met:
·

The engine hood is opened when the engine hood is closed.

·

Any door is opened when all doors are closed.

·

Any door is unlocked when all doors are locked not by wireless operation or entry operation.

·

When 5 seconds or more have elapsed after the power switch is pressed, the ignition switch is turned from off to ON without pressing the power switch. (for HV Model)

·

When 5 seconds or more have elapsed after the engine switch is pressed, the ignition switch is turned from off to ON without pressing the engine switch. (for Gasoline Model)

·

The auxiliary battery is reconnected when the engine hood is open, any door is open or any door is unlocked.

·

The ignition switch is ON.


Condition [9] If both of the following conditions are met, the alarm stops and the system returns to Armed State (1).
·

After warning time of 27.5 seconds + warning waiting time of 5 seconds elapses.

·

The engine hood was opened prior to the alarm condition.


Condition [10] One of the following conditions is met:
·

The engine hood is opened when the engine hood is closed.

·

Any door is opened when all doors are closed.

·

Any door is unlocked when all doors are locked not by wireless operation or entry operation.

·

When 5 seconds or more have elapsed after the power switch is pressed, the ignition switch is turned from off to ON without pressing the power switch. (for HV Model)

·

When 5 seconds or more have elapsed after the engine switch is pressed, the ignition switch is turned from off to ON without pressing the engine switch. (for Gasoline Model)

·

The auxiliary battery is reconnected when the engine hood is open, any door is open or any door is unlocked.

·

The ignition switch is ON.


Condition [11] If both of the following conditions are met, the alarm stops and the system returns to Armed State (2).
·

After warning time of 27.5 seconds + warning waiting time of 5 seconds elapses.

·

The engine hood was closed before the alarm condition.


Condition [12]
·

The engine hood is closed when the engine hood is opened.



w/o Entry and Start System
Condition Item
Condition [1] In disarmed state 1, when the ignition switch is off, the system state is switched if the following condition is met when the key is not in the key cylinder:
·

With all doors and the engine hood closed, all doors are locked by wireless operation.


Condition [2] In disarmed state 1, when the ignition switch is off, the system state is switched if the following condition is met when the key is not in the key cylinder:
·

With all doors and the engine hood opened, all doors are locked by wireless operation.


Condition [3] One of the following conditions is met:
·

All doors are unlocked by wireless operation or key linked lock operation.

·

Any door is unlocked.

·

Any door is opened.

·

The ignition switch is turned to ACC or ON.

·

The auxiliary battery is reconnected.

·

The key is in the ignition key cylinder.


Condition [4]
·

The engine hood is opened.


Condition [5]
·

Allow approximately 30 seconds to elapse.


Condition [6]
·

The engine hood is closed.


Condition [7] One of the following conditions is met:
·

for Gasoline Model:

The ignition switch is turned to ON and the engine is running at 550 rpm for 2 seconds or more.

·

for HV Model:

The ignition switch is turned to ON (READY).

·

All doors are unlocked by wireless operation or key linked lock operation.


Condition [8] One of the following conditions is met:
·

The engine hood is opened when the engine hood is closed.

·

Any door is opened when all doors are closed.

·

Any door is unlocked when all doors are locked not by wireless operation.

·

The auxiliary battery is reconnected when the engine hood is open, any door is open or any door is unlocked.

·

The ignition switch is ON.


Condition [9] If both of the following conditions are met, the alarm stops and the system returns to Armed State (1).
·

After warning time of 27.5 seconds + warning waiting time of 5 seconds elapses.

·

The engine hood was opened prior to the alarm condition.


Condition [10] One of the following conditions is met:
·

The engine hood is opened when the engine hood is closed.

·

Any door is opened when all doors are closed.

·

Any door is unlocked when all doors are locked not by wireless operation.

·

The auxiliary battery is reconnected when the engine hood is open, any door is open or any door is unlocked.

·

The ignition switch is ON.


Condition [11] If both of the following conditions are met, the alarm stops and the system returns to Armed State (2).
·

After warning time of 27.5 seconds + warning waiting time of 5 seconds elapses.

·

The engine hood was closed before the alarm condition.


Condition [12]
·

The engine hood is closed when the engine hood is opened.





FORCED DOOR LOCK CONTROL


a.

The forced door lock control prevents the vehicle from being tampered with. Immediately after a door is unlocked (armed state), all doors are forced to lock by a forced door lock signal.

i.

If the following conditions are met, the forced door lock control is operated.

·

The key is not in the key cylinder.

·

The theft deterrent system is in the armed state.

·

Any door is unlocked.





SECURITY INDICATOR LIGHT OUTPUT


a.

According to the state of the theft deterrent system, the main body ECU (multiplex network body ECU) outputs a signal to turn the security indicator light on. However, some of the actual lighting conditions of the security indicator light are different from the output signals of the main body ECU (multiplex network body ECU).

Output
State of Theft Deterrent System Security Indicator Light
Output Signal from Main Body ECU (Multiplex Network Body ECU) Actual Lighting Condition
Disarmed state Off
·

Off (Immobiliser function unset)

·

Blinking (Immobiliser function set)


Arming preparation state (1), (2) On On
Armed state (1), (2) Off Blinking (Immobiliser function set)
Alarm sounding state On On

Blinking Cycle
Time Security Indicator Light
0.125 seconds On
1.875 seconds Off

HINT:

When the immobiliser function is set, the security indicator light blinks during both the disarmed state and the armed state due to output signals from the immobiliser function.