PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
After the ignition switch is turned off, the radio and display receiver assembly records various types of memory and settings. As a result, after turning the ignition switch off, make sure to wait at least 120 seconds before disconnecting the cable from the negative (-) auxiliary battery terminal.
PRECAUTION FOR NAVIGATION SYSTEM
When performing the following work, the navigation system may restart when turning the ignition switch to ACC (due to radio and display receiver assembly and navigation ECU certification).
Repair or replace the negative (-) auxiliary battery terminal due to it being disconnected or depleted.
The radio and display receiver assembly or navigation ECU replacement or removal and installation.
After replacing the radio and display receiver assembly, if "New software is not compatible with the system. Contact your dealer." is displayed on the multi-display, update the software of the navigation ECU.
After replacing the navigation ECU, if "New software is not compatible with the system. Contact your dealer." is displayed on the multi-display, update the software of the radio and display receiver assembly.
When replacing the telephone transceiver assembly, make sure to replace it with a new one. (w/ Telephone Transceiver Assembly)
If any of the following parts are replaced, refer to Initialization in Repair Instruction.
Click hereGeneral>SETUP>WHEN REPLACING OR REMOVING/INSTALLING PARTS>WORK PROCEDURE
Telephone transceiver assembly*
*: w/ Telephone Transceiver Assembly