This is the power source circuit to operate the radio and display receiver assembly.
Inspect the fuses for circuits related to this system before performing the following procedure.
Check the vehicle type.
| Result | Proceed to |
|---|---|
| w/o Stop and Start System | A |
| w/ Stop and Start System | B |
A
B
Disconnect the H79 and H80 radio and display receiver assembly connectors.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| H79-1 (GND1) - Body ground | Always | Below 1 Ω |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| H79-4 (+B1) - H79-1 (GND1) | Ignition switch off | 11 to 14 V |
| H79-15 (ACC1) - H79-1 (GND1) | Ignition switch ACC | 11 to 14 V |
| H80-19 (IG) - H79-1 (GND1) | Ignition switch ON | 11 to 14 V |
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM>PROBLEM SYMPTOMS TABLE
NG
Disconnect the H79 and H80 radio and display receiver assembly connectors.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| H79-1 (GND1) - Body ground | Always | Below 1 Ω |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| H79-4 (+B1) - H79-1 (GND1) | Ignition switch off | 10.5 to 16 V |
| H79-15 (ACC1) - H79-1 (GND1) | Ignition switch ACC | 10.5 to 16 V |
| H80-19 (IG) - H79-1 (GND1) | Ignition switch ON | 11 to 14 V |
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM>PROBLEM SYMPTOMS TABLE
NG
Click hereEngine / Hybrid System>STOP AND START>STOP AND START SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING