Home › Vehicle Interior › PRE-COLLISION › PRE-COLLISION SYSTEM › from 2020.07
RM36W0E _58 Vehicle Interior _089448 PRE-COLLISION _0424816 PRE-COLLISION SYSTEM U

PRE-COLLISION  PRE-COLLISION SYSTEM  TERMINALS OF ECU  


CHECK MILLIMETER WAVE RADAR SENSOR ASSEMBLY


NOTICE:
·

Turning the ignition switch to ON with connectors disconnected may cause DTCs to be stored. Make sure to clear the DTCs after inspection has been performed.

·

Do not apply excessive force to the millimeter wave radar sensor assembly connector.



A402620E22
3.365,0.063 3.792,0.302 0.427,0.24 3.448,0.083 3.906,0.281 0.458,0.198 10 false B8

a.

Measure the voltage and resistance according to the value(s) in the table below.

Terminal No. (Symbol) Terminal Description Condition Specified Condition
B8-8 (IGB) - B8-1 (SGND) Power source Ignition switch ON 11 to 14 V*1
10.5 to 16 V*2
Ignition switch off Below 1 V
B8-1 (SGND) - Body ground Ground Always Below 1 Ω

*1: w/o Stop and Start System

*2: w/ Stop and Start System