Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › FRONT SEAT SIDE AIRBAG ASSEMBLY › 2020.07–2020.09
RM36W0E _58 Vehicle Interior _088020 SUPPLEMENTAL RESTRAINT SYSTEMS _0421876 FRONT SEAT SIDE AIRBAG ASSEMBLY A

SUPPLEMENTAL RESTRAINT SYSTEMS  FRONT SEAT SIDE AIRBAG ASSEMBLY  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the front seat airbag assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effects/Inoperative when not performed Link
Disconnect cable from negative auxiliary battery terminal Memorize steering angle neutral point Parking assist monitor system (Click here)

HINT:

When the cable is disconnected / reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

·

Learning completes when vehicle is driven

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link

*1: for Gasoline Model

Lane tracing assist system Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 seconds or more. (Click here)
Pre-collision system
Stop and start system *1 Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes) (Click here)

·

Learning completes when vehicle is operated normally

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Power door lock control system
·

Back door opener


Perform door unlock operation with door control switch or electrical key transmitter sub-assembly switch. (Click here)
Air conditioning system After the ignition switch is turned to ON, the servo motor standard position is recognized. -



PROCEDURE

Hide 1. PRECAUTION

CAUTION:
·
B475753

Be sure to read Precaution thoroughly before servicing.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION

·
B394717

Wear protective gloves. Sharp areas on the parts may injure your hands.



NOTICE:

If a front seat airbag assembly has been deployed, replace the front seat airbag assembly, front seatback frame sub-assembly, separate type front seatback pad and separate type front seatback cover with the necessary parts in accordance with the extent of the collision damage.


HINT:
·

Use the same procedure for the driver side and front passenger side.

·

The procedure listed below is for the driver side.



Hide 73230 2.REMOVE FRONT SEAT INNER BELT ASSEMBLY

Hide 71910E 3.REMOVE FRONT SEAT HEADREST ASSEMBLY

Hide 72494A 4.REMOVE FRONT SEAT VERTICAL ADJUSTER HANDLE (for Driver Side)

Hide 72551B 5.REMOVE RECLINING HINGE COVER

Hide 72525A 6.REMOVE RECLINING ADJUSTER RELEASE HANDLE

Hide 71848A 7.REMOVE SEAT ADJUSTER COVER CAP (for Driver Side)

Hide 71811D 8.REMOVE FRONT SEAT CUSHION SHIELD (for Driver Side)

Hide 71861 9.REMOVE FRONT SEAT INNER CUSHION SHIELD (for Driver Side)

Hide 71812D 10.REMOVE FRONT SEAT CUSHION SHIELD (for Front Passenger Side)

Hide 71862 11.REMOVE FRONT SEAT INNER CUSHION SHIELD (for Front Passenger Side)

Hide 12.REMOVE SEPARATE TYPE FRONT SEATBACK ASSEMBLY

Hide 71930E 13.REMOVE FRONT SEAT HEADREST SUPPORT ASSEMBLY

Hide 14.REMOVE SEPARATE TYPE FRONT SEATBACK COVER WITH PAD

Hide 73910A 15.REMOVE FRONT SEAT AIRBAG ASSEMBLY

CAUTION:
B399378C01
0,0 0,0 false
V100155

Deployment Side


·

When storing the front seat airbag assembly, keep the airbag deployment side facing upward.

·

If the airbag deploys for any reason, it may cause a serious accident.



a.
B583379

Disengage the clamp.


b.

Remove the 2 nuts and front seat airbag assembly.

CAUTION:
·

Do not reuse the nut.

·

If the installation surface or surrounding area of the front seat airbag assembly is deformed or damaged, replace the front seatback frame sub-assembly with a new one.




Hide 739H0 16.REMOVE FRONT SEAT CENTER AIRBAG ASSEMBLY

CAUTION:
B399378C01
0,0 0,0 false
V100155

Deployment Side


·

When storing the front seat center airbag assembly, keep the airbag deployment side facing upward.

·

If the airbag deploys for any reason, it may cause a serious accident.



a.
B583378

Disengage the clamp.


b.

Remove the 2 nuts and front seat center airbag assembly.

CAUTION:
·

Do not reuse the nut.

·

If the installation surface or surrounding area of the front seat center airbag assembly is deformed or damaged, replace the front seat center airbag assembly with a new one.