Home › Engine / Hybrid System › 1KR-FE (ENGINE CONTROL) › VACUUM SENSOR › from 2020.07
RM36W0E _51 Engine / Hybrid System _091054 1KR-FE ENGINE CONTROL _0440647 VACUUM SENSOR A

1KR-FE ENGINE CONTROL  VACUUM SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

NOTICE:

After the ignition switch is turned off, the radio and display receiver assembly records various types of memory and settings. As a result, after turning the ignition switch off, make sure to wait at least 120 seconds before disconnecting the cable from the negative (-) auxiliary battery terminal.


HINT:

When the cable is disconnected/reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

·

Learning completes when vehicle is driven

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Lane tracing assist system Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 second or more. (Click here)
Pre-collision system
Stop and start system Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes) (Click here)

·

Learning completes when vehicle is operated normally

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Power door lock control system
·

Back door opener


Perform door unlock operation with door control switch or electrical key transmitter sub-assembly switch. (Click here)
Air conditioning system After the ignition switch is turned to ON, the servo motor standard position is recognized. -



PROCEDURE

Hide 47201 1.REMOVE BRAKE MASTER CYLINDER SUB-ASSEMBLY (for LHD)

Hide 47201 2.REMOVE BRAKE MASTER CYLINDER SUB-ASSEMBLY (for RHD)

Hide 89420H 3.REMOVE VACUUM SENSOR ASSEMBLY

a.
A468073C01
0.073,0.406 0.313,0.635 0.24,0.229 12 true *A 0.063,2.698 0.354,2.906 0.292,0.208 12 true *B
*A for LHD
*B for RHD


Disconnect the vacuum sensor assembly connector from the vacuum sensor assembly.


b.

Remove the vacuum sensor assembly from the brake booster assembly.


Hide 4.REMOVE VACUUM SENSOR GROMMET

a.

Remove the vacuum sensor grommet from the brake booster assembly.