The skid control ECU (brake booster with master cylinder assembly) outputs this DTC when it receives a sensor power source malfunction signal from the steering sensor.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | DTC Output from |
|---|---|---|---|---|
| C14FE14 | Steering Angle Sensor Supply Voltage Circuit Circuit Short to Ground or Open | Steering sensor power supply malfunction signal is received from steering sensor. | ·
Wire harness or connector ·
Steering sensor |
Brake |
Refer to DTCs C05262A.
Inspect the fuses for circuits related to this system before performing the following procedure.
Clear the DTCs.
Turn the ignition switch off.
| Proceed to |
|---|
| NEXT |
NEXT
Based on the Freeze Frame Data and interview with the customer, attempt to reproduce the conditions when the malfunction occurred.
Check if the same DTC is output
| Result | Proceed to |
|---|---|
| C14FE14 is not output | A |
| C14FE14 is output | B |
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B
Remove the steering wheel and column cover.
Make sure that there is no looseness at the locking part and the connecting part of the connector.
The connector is securely connected.
Disconnect the H39 steering sensor connector.
Check both the connector case and the terminals for deformation and corrosion.
No deformation or corrosion.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| H39-4 (BAT) - Body ground | Always | 11 to 14 V |
| H39-9 (IGR) - Body ground | Ignition switch ON | 11 to 14 V |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Turn the ignition switch off.
Measure the resistance according to the value(s) in the table below.
Before measuring the resistance of the steering sensor, turn the ignition switch off and leave the vehicle for 1 minute or more without operating the key or switches, or opening or closing the doors.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| H39-6 (ESS) - Body ground | 1 minute after ignition switch off | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG