The skid control ECU (brake actuator assembly) receives signals from the steering sensor via CAN communication.
When a malfunction occurs in the communication line to the steering sensor, U012687 is output.
If a DTC related to the CAN communication line is output, first troubleshoot the CAN communication line.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | DTC Output from |
|---|---|---|---|---|
| C05262A | Steering Angle Sensor Module Signal Stuck In Range | Normal communication between the skid control ECU and the steering sensor and abnormal steering sensor zero point. | ·
Steering sensor ·
Wire harness and connector |
Brake |
Inspect the fuses for circuits related to this system before performing the following procedure.
Operate the GTS to clear the codes.
Turn the ignition switch off.
| Proceed to |
|---|
| NEXT |
NEXT
Operate the GTS, and check for DTCs related to the CAN communication system.
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM (for Gasoline Model)>DIAGNOSIS SYSTEM
| Result | Proceed to |
|---|---|
| Any CAN communication system relating DTCs are output | A |
| None of the above conditions are met | B |
A
B
Pre-procedure1
Drive the vehicle at a speed of 35 km/h (22 mph) and turn the steering wheel to the right and left.
Procedure1
Operate the GTS to read the DTCs.
Check that no speed sensor or yaw rate sensor (yaw rate and acceleration sensor) DTCs are output.
If a speed sensor, or the yaw rate sensor (yaw rate and acceleration sensor) is malfunctioning, DTCs for the steering sensor may be stored even though the steering sensor is normal.
If speed sensor and yaw rate sensor (yaw rate and acceleration sensor) DTCs are output simultaneously, repair these malfunctions and then inspect the steering sensor.
Post-procedure1
Turn the ignition switch off.
| Result | Proceed to |
|---|---|
| Only C05262A is output | A |
| Speed sensor or yaw rate and acceleration sensor DTCs are output | B |
| None of the above conditions are met | C |
A
B
C
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
Pre-procedure1
Make sure that there is no looseness at the locking part and the connecting part of the connectors.
The connector is securely connected.
Disconnect the H39 steering sensor connector.
Check both the connector case and the terminals for deformation and corrosion.
No deformation or corrosion.
Pre-procedure2
Turn the ignition switch to ON.
Procedure1
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| H39-9 (IGR) - Body ground | Ignition switch ON | 11 to 14 V |
Post-procedure1
Turn the ignition switch off.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| H39-4 (BAT) - Body ground | Always | 11 to 14 V |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| H39-6 (ESS) - Body ground | 1 minute or more after disconnecting the cable from the negative (-) auxiliary battery terminal | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG