The power steering ECU assembly distinguishes the ignition switch status as ON or off through the IG power source circuit.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Warning Indicate | Return-to-normal Condition | Note |
|---|---|---|---|---|---|---|
| C123A17 | Supply Voltage Circuit Circuit Voltage Above Threshold | IG voltage is 18.5 V or more | ·
EPS-IGR fuse ·
IG power source circuit ·
Power steering ECU assembly |
EPS warning light: Comes on | The ECU judges the system has returned to normal or the ignition switch is turned ON again | - |
When the power steering ECU assembly has been replaced, perform Power Steering ECU Initial Setting (assist map writing).
Click hereSteering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>CALIBRATION
Inspect the fuses for circuits related to this system before performing the following procedure.
Disconnect the H1 power steering ECU assembly connectors.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| H1-1 (IG) - Body ground | Ignition switch ON | 8 to 16 V |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the H2 power steering ECU assembly connectors.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| H2-2 (PGND) - Body ground | Always | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
for LHD: Click hereSteering>POWER ASSIST SYSTEMS>POWER STEERING ECU (for LHD)>REMOVAL
for RHD: Click hereSteering>POWER ASSIST SYSTEMS>POWER STEERING ECU (for RHD)>REMOVAL
NG