Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING SYSTEM › from 2020.07
RM36W0E _55 Steering _087549 POWER ASSIST SYSTEMS _0419673 POWER STEERING SYSTEM C

POWER ASSIST SYSTEMS  POWER STEERING SYSTEM  C151162  Power Steering Torque Sensor "A" Signal Compare Failure  C151187  Power Steering Torque Sensor "A" Missing Message  C151262  Power Steering Torque Sensor "B" Signal Compare Failure  C151287  Power Steering Torque Sensor "B" Missing Message  


DESCRIPTION

The power steering ECU assembly supplies a voltage of 5 V to the torque sensor (electric power steering column sub-assembly) and monitors the voltage value of the Hall IC inside the torque sensor (electric power steering column sub-assembly) which changes in response to changes in the magnetic flux density (steering torque) detected by the Hall IC, and calculates the assist torque.

While DTC C151162, C151187, C151262 or C151287 is detected, power assist is stopped or assist amount is limited due to fail-safe operation.

DTC No. Detection Item DTC Detection Condition Trouble Area Warning Indicate Return-to-normal Condition Note
C151162 Power Steering Torque Sensor "A" Signal Compare Failure Diagnosis Condition: IG ON
Malfunction Status: The difference between 1A and 1B of the TRQ1 output signal is more than a certain value.
·

Torque sensor (Electric power steering column sub-assembly)

·

Power steering ECU assembly


EPS warning light: Comes on Ignition switch ON again -
C151187 Power Steering Torque Sensor "A" Missing Message Diagnosis Condition: IG ON
Malfunction Status: When the battery voltage is 9.0 V or more, the TRQ1 signal is not detected, breaks communication protocol, has a CRC error, or has an invalid rolling counter.
·

Torque sensor (Electric power steering column sub-assembly)

·

Power steering ECU assembly


EPS warning light: Comes on Ignition switch ON again -
C151262 Power Steering Torque Sensor "B" Signal Compare Failure Diagnosis Condition: IG ON
Malfunction Status: The difference between 2A and 2B of the TRQ2 output signal is more than a certain value.
·

Torque sensor (Electric power steering column sub-assembly)

·

Power steering ECU assembly


EPS warning light: Comes on Ignition switch ON again -
C151287 Power Steering Torque Sensor "B" Missing Message Diagnosis Condition: IG ON
Malfunction Status: When the battery voltage is 9.0 V or more, the TRQ2 signal is not detected, breaks communication protocol, has a CRC error, or has an invalid rolling counter.
·

Torque sensor (Electric power steering column sub-assembly)

·

Power steering ECU assembly


EPS warning light: Comes on Ignition switch ON again -

CAUTION / NOTICE / HINT

NOTICE:
·

When the electric power steering column sub-assembly has been replaced, perform Power Steering ECU Initial Setting (assist map writing).

Click hereSteering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>CALIBRATION

·

When the power steering ECU assembly has been replaced, perform Power Steering ECU Initial Setting (assist map writing).

Click hereSteering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>CALIBRATION



PROCEDURE

1.REPLACE POWER STEERING ECU ASSEMBLY AND ELECTRIC POWER STEERING COLUMN SUB-ASSEMBLY

b.

Replace the electric power steering column sub-assembly.

Click hereSteering>STEERING COLUMN>STEERING COLUMN ASSEMBLY>REMOVAL


Result:
Proceed to
NEXT



NEXT

END