CUSTOMIZE WIPER AND WASHER SYSTEM
When the customer requests a change in a function, first make sure that the function can be customized.
Be sure to make a note of the current settings before customizing.
When troubleshooting a function, first make sure that the function is set to the default setting.
The following items can be customized.
Select the setting by referring to the table below.
| Tester Display | Description | Default | Setting | ECU |
|---|---|---|---|---|
| R Wiper Stop Function at Back Door/Trunk Lid Open | Function to enable the back door open linked rear wiper suspend function*1 | Disable | $00:Enable,$01:Disable | Main body ECU (Multiplex network body ECU) |
| Rear Wiper Washer Function | Function to enable the rear washer linked rear wiper operation function*1 | Enable | $00:Enable,$01:Disable | Main body ECU (Multiplex network body ECU) |
| Rear Wiper with Reverse Setting | Function to enable the R shift position linked rear wiper operation function*1 | 1time | $00:Disable,$02:1 time,$03:Continuation | Main body ECU (Multiplex network body ECU) |
| Auto Wiper | Function to enable AUTO wiper operation*2 | Avail | 0:Avail,1:Not Avl | Rain sensor |
*1: w/ Rear Wiper System
*2: w/ Auto Wiper System
Changes to the customize settings will not be applied until the ignition switch is turned off then ON.