55479D
1.REMOVE LOWER INSTRUMENT CLUSTER FINISH PANEL GARNISH
|
Protective Tape |
|
Remove in this Direction |
Using a screwdriver with its tip wrapped in protective tape, disengage the claw and guide to remove the lower instrument cluster finish panel garnish as shown in the illustration.
55432B
2.REMOVE LOWER INSTRUMENT PANEL FINISH PANEL
|
Remove in this Direction |
Disengage the clips, claws and guides to remove the lower instrument panel finish panel as shown in the illustration.
w/ Entry and Start System:
Disconnect the connector.
55407B
3.REMOVE SWITCH HOLE BASE SUB-ASSEMBLY
|
Remove in this Direction |
Disengage the clips and guide to disconnect the console box assembly as shown in the illustration.
|
Remove in this Direction |
Disengage the clip and guides to remove the switch hole base sub-assembly as shown in the illustration.
Disconnect each connector.
33504F
4.REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY
|
Remove in this Direction |
Turn the shift lever knob sub-assembly as shown in the illustration and remove it.
58810J
5.REMOVE CONSOLE BOX ASSEMBLY
| *a | Portion A |
To avoid damaging the console box assembly, do not attempt to remove the console box assembly while your hands are only holding portion A in the illustration.
|
Remove in this Direction |
Disengage the clips and guide so that the console box assembly is lifted up as shown in the illustration.
|
Remove in this Direction |
Disengage the clips and guides to remove the console box assembly as shown in the illustration.
Disconnect the 2 connectors.
Disengage the clamp.
58903A
6.REMOVE CONSOLE REAR END PANEL SUB-ASSEMBLY
|
Remove in this Direction |
Disengage the clips and guide to remove the console rear end panel sub-assembly.
58822A
7.REMOVE REAR UPPER CONSOLE PANEL
|
Remove in this Direction |
Disengage the clips to remove the rear upper console panel as shown in the illustration.
Disconnect the connector.
Disengage the clamp.
58910C
8.REMOVE REAR CONSOLE BOX ASSEMBLY
|
Remove in this Direction (1) |
|
Remove in this Direction (2) |
Remove the 2 screws.
Remove the 2 bolts.
Disengage the guides and claws to remove the rear console box assembly as shown in the illustration.