86101J
1.INSTALL NO. 2 ANTENNA CORD SUB-ASSEMBLY
82171
2.INSTALL NO. 1 ROOF WIRE
Apply butyl tape onto the roof headlining so that it does not protrude from the markings.
|
Butyl Tape | - | - |
Apply the butyl tape securely, making sure that it is not out of position or peeling off.
Line up the No. 1 roof wire positioning tape and the roof headlining markings.
| *A | w/ Pre-collision System | - | - |
| *a | Positioning Tape | *b | Marking |
Install the No. 1 roof wire with 12 new pieces of adhesive tape.
| *A | w/ Pre-collision System | - | - |
| *a | Adjustment Area | - | - |
Apply the tape securely in place.
Do not touch the adhesive surface when applying the tape to prevent adhesion failure.
Adjust the slack of the No. 1 roof wire as shown in the adjustment area of illustration.
63342
3.INSTALL NO. 3 ROOF SILENCER PAD
Align the markings on the roof headlining with the No. 3 roof silencer pad and install them using hot melt glue.
| *a | Marking | - | - |
63342
4.INSTALL NO. 2 ROOF SILENCER PAD
Align the markings on the roof headlining with the No. 2 roof silencer pad and install them using hot melt glue.
| *a | Marking | - | - |
63341
5.INSTALL NO. 1 ROOF SILENCER PAD
Align the markings on the roof headlining with the No. 1 roof silencer pad and install them using hot melt glue.
| *a | Marking | - | - |
63345
6.INSTALL NO. 4 ROOF SILENCER PAD
Align the markings on the roof headlining with the 2 No. 4 roof silencer pads and install them using hot melt glue.
| *a | Marking | - | - |
63388A
7.INSTALL ROOF HEADLINING HOLDER COVER (w/ Active Noise Control System)
Engage the claws to install the roof headlining holder cover.
8.INSTALL ACTIVE NOISE CONTROL MICROPHONE (w/ Active Noise Control System)