Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › FRONT BUMPER (for 3 Door) › from 2020.09
RM36W0E _59 Vehicle Exterior _088302 EXTERIOR PANELS / TRIM _0447292 FRONT BUMPER(for 3 Door) A

EXTERIOR PANELS / TRIM  FRONT BUMPER(for 3 Door)  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during front bumper assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function When Necessary Procedures are not Performed Link
w/ Parking Support Brake System:

Front bumper assembly (Including removal and installation)


·

Ultrasonic sensor detection angle

·

Ultrasonic sensor detection angle registration


Parking support brake system (Click here)

PROCEDURE

Hide 47749F 1.REMOVE PIN HOLD CLIP

a.
B591231C01
0.302,1.469 0.271,0.865 0.271,0.865 0.417,0.542 false 0.104,0.74 0.417,0.938 0.313,0.198 10 false *a
*a Protective Tape


Using a screwdriver with its tip wrapped in protective tape, disengage the claw to remove the 2 pin hold clips.

HINT:

Use the same procedure for the RH side and LH side.



Hide 2.REMOVE FRONT BUMPER ASSEMBLY

a.
B591232C01
0,0 0,0 false
V100155

Protective Tape


Apply protective tape around the front bumper assembly.

HINT:

Use the same procedure for the RH side and LH side.



b.
B591233

Remove the 10 screws.


c.
B591234

Remove the screw.

HINT:

Use the same procedure for the RH side and LH side.



d.
B591235C01
0,0 0,0 false
V113147

Remove in this Direction


Disengage the claws to remove the bracket as shown in the illustration.

HINT:

Use the same procedure for the RH side and LH side.



e.
B591236C01
0,0 0,0 false
V113147

Remove in this Direction


Disengage the claws as shown in the illustration.

HINT:

Use the same procedure for the RH side and LH side.



f.

Pull back the side of the front bumper assembly.

B591237

NOTICE:

Do not apply excessive force when pulling back the front bumper assembly.



g.

Disconnect the 2 connectors.


h.
B591238

Disconnect the connector.


i.
B591239

Remove the 2 clips and 2 bolts.


j.
B591240

Remove the 3 grommets.

HINT:

Use the same procedure for the RH side and LH side.