Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › FRONT BUMPER (for 3 Door) › from 2020.09
RM36W0E _59 Vehicle Exterior _088302 EXTERIOR PANELS / TRIM _0447292 FRONT BUMPER(for 3 Door) A

EXTERIOR PANELS / TRIM  FRONT BUMPER(for 3 Door)  INSTALLATION  


PROCEDURE

Hide 1.INSTALL FRONT BUMPER ASSEMBLY

a.

Install the 3 grommets.

HINT:

Use the same procedure for the RH side and LH side.



b.

Temporarily install the front bumper assembly.


c.

Install the 2 clips and 2 bolts.


d.

Connect the connector.


e.

Pull back the side of the front bumper assembly.

B591237

NOTICE:

Do not apply excessive force when pulling back the front bumper assembly.



f.

Connect the 2 connectors.


g.
B577634C01
0,0 0,0 false
V113147

Install in this Direction


Engage the claws as shown in the illustration.

HINT:

Use the same procedure for the RH side and LH side.



h.
B596007C01
0,0 0,0 false
V113147

Install in this Direction


Engage the claws to install the bracket as shown in the illustration.

HINT:

Use the same procedure for the RH side and LH side.



i.

Install the screw.

HINT:

Use the same procedure for the RH side and LH side.



j.

Install the 10 screws.


Hide 47749F 2.INSTALL PIN HOLD CLIP

a.

Engage the claw to install the 2 pin hold clips.

HINT:

Use the same procedure for the RH side and LH side.



Hide 4.ADJUST MILLIMETER WAVE RADAR SENSOR (w/ Toyota Safety Sense 2)

a.

When the millimeter wave radar sensor assembly is replaced with a new one, adjustment of the radar sensor beam axis must be performed.

HINT:

Millimeter wave radar sensor assembly Learning can be performed by using either Triangle Target or Flat Surface Target or Driving Adjustment.




Hide 5.PERFORM CALIBRATION (w/ Parking Support Brake System)