1.INSTALL REAR BUMPER ASSEMBLY
|
Install in the Direction |
Connect the connector.
Engage the claws to install the rear bumper assembly as shown in the illustration.
|
Install in the Direction |
Engage the claws as shown in the illustration.
Use the same procedure for the RH side and LH side.
Install the 2 clips.
Install the 2 rear bumper cushions.
Remove the protective tape.
52592
2.INSTALL REAR BUMPER SIDE SEAL LH
Install the rear bumper side seal LH with 4 clips.
52591
3.INSTALL REAR BUMPER SIDE SEAL RH
Use the same procedure as for the LH side.
4.PERFORM CALIBRATION (w/ Parking Support Brake System)