Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › REAR BUMPER (for 3 Door) › from 2020.09
RM36W0E _59 Vehicle Exterior _088302 EXTERIOR PANELS / TRIM _0447294 REAR BUMPER(for 3 Door) A

EXTERIOR PANELS / TRIM  REAR BUMPER(for 3 Door)  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during rear bumper assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function When Necessary Procedures are not Performed Link
w/ Parking Support Brake System:

Rear bumper assembly (Including removal and installation)


·

Ultrasonic sensor detection angle

·

Ultrasonic sensor detection angle registration


Parking support brake system (Click here)

PROCEDURE

Hide 52592 1.REMOVE REAR BUMPER SIDE SEAL LH

a.
B596048

Remove the 6 clips to remove the rear bumper side seal LH.


Hide 52591 2.REMOVE REAR BUMPER SIDE SEAL RH

HINT:

Use the same procedure as for the LH side.


Hide 3.REMOVE REAR BUMPER ASSEMBLY

a.
B596049C01
0,0 0,0 false
V100155

Protective Tape


Apply protective tape around the rear bumper assembly.

HINT:

Use the same procedure for the RH side and LH side.



b.
B596050

Remove the 2 rear bumper cushions.


c.
B596051

Remove the 2 clips.


d.
B596052C01
0,0 0,0 false
V113147

Remove in this Direction


Disengage the claws as shown in the illustration.

HINT:

Use the same procedure for the RH side and LH side.



e.
B596053C01
0,0 0,0 false
V113147

Remove in this Direction


Disengage the claws as shown in the illustration.


f.

Disconnect the connector to remove the rear bumper assembly.