Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › REAR SPEED SENSOR (for TMC Made G16E-GTS) › from 2020.09
RM36W0E _54 Brake _088016 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0447321 REAR SPEED SENSOR(for TMC Made G16E-GTS) A

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  REAR SPEED SENSOR(for TMC Made G16E-GTS)  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.

·

If the rear speed sensor rotor needs to be replaced, replace the rear axle hub and bearing assembly.



PROCEDURE

Hide 1.REMOVE REAR WHEEL

Hide 62520B 2.REMOVE QUARTER TRIM PANEL ASSEMBLY

Hide 46430 3.SEPARATE NO. 3 PARKING BRAKE CABLE ASSEMBLY

a.
C444977

Remove the nut to separate the No. 3 parking brake cable assembly.


Hide 89546 4.REMOVE REAR SPEED SENSOR

a.
C444978

Disconnect the rear speed sensor connector inside of the vehicle.


b.
C444979

Remove the bolt and separate the rear speed sensor from the vehicle body.


c.

Remove the bolt and separate the rear speed sensor from the rear trailing arm assembly.


d.

Disengage the clamp and separate the rear speed sensor from the rear trailing arm assembly.


e.
C444980

Disengage the clamp and separate the rear speed sensor from the rear trailing arm assembly.


f.
C444981

Remove the bolt to separate the rear speed sensor from the rear axle carrier sub-assembly.


g.
C445368

Disengage the grommet and remove the rear speed sensor.

NOTICE:
·

When disengaging the grommet, take care not to damage the rear speed sensor wire harness.

·

Do not forcibly pull the rear speed sensor wire harness as it may become damaged.