84810
1.INSPECT POWER WINDOW REGULATOR SWITCH ASSEMBLY (for LHD)
Check the resistance.
| *a | Component without harness connected
(Power Window Regulator Switch Assembly) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| K13-5 (UP) - K13-7 (GND) | Auto up or up position | Below 100 Ω |
| K13-4 (DOWN) - K13-7 (GND) | Auto down or down position | Below 100 Ω |
| K13-8 (AUTO) - K13-7 (GND) | Auto up or auto down position | Below 100 Ω |
| K13-5 (UP) - K13-7 (GND) | Off | 10 kΩ or higher |
| K13-4 (DOWN) - K13-7 (GND) | Off | 10 kΩ or higher |
| K13-8 (AUTO) - K13-7 (GND) | Off | 10 kΩ or higher |
If the result is not as specified, replace the power window regulator switch assembly.
Check that the LED illuminates. (for 3 Door)
| *a | Component without harness connected
(Power Window Regulator Switch Assembly) |
Apply auxiliary battery voltage to the power window regulator switch assembly and check that the LED illuminate.
| Tester Connection | Specified Condition |
|---|---|
| K13-3 (ILL+) - Auxiliary battery positive (+)
K13-13 (ILL-) - Auxiliary battery negative (-) |
LED illuminate |
If the result is not as specified, replace the power window regulator switch assembly.
84810
2.INSPECT POWER WINDOW REGULATOR SWITCH ASSEMBLY (for RHD)
Check the resistance.
| *a | Component without harness connected
(Power Window Regulator Switch Assembly) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| L6-5 (UP) - L6-7 (GND) | Auto up or up position | Below 100 Ω |
| L6-4 (DOWN) - L6-7 (GND) | Auto down or down position | Below 100 Ω |
| L6-8 (AUTO) - L6-7 (GND) | Auto up or auto down position | Below 100 Ω |
| L6-5 (UP) - L6-7 (GND) | Off | 10 kΩ or higher |
| L6-4 (DOWN) - L6-7 (GND) | Off | 10 kΩ or higher |
| L6-8 (AUTO) - L6-7 (GND) | Off | 10 kΩ or higher |
If the result is not as specified, replace the power window regulator switch assembly.
Check that the LED illuminates. (for 3 Door)
| *a | Component without harness connected
(Power Window Regulator Switch Assembly) |
Apply auxiliary battery voltage to the power window regulator switch assembly and check that the LED illuminate.
| Tester Connection | Specified Condition |
|---|---|
| L6-3 (ILL+) - Auxiliary battery positive (+)
L6-13 (ILL-) - Auxiliary battery negative (-) |
LED illuminate |
If the result is not as specified, replace the power window regulator switch assembly.