Home › Brake › BRAKE SYSTEM (OTHER) › VACUUM PUMP (for TMC Made M15A-FKS) › from 2020.09
RM36W0E _54 Brake _088656 BRAKE SYSTEM (OTHER) _0447365 VACUUM PUMP(for TMC Made M15A-FKS) G

BRAKE SYSTEM (OTHER)  VACUUM PUMP(for TMC Made M15A-FKS)  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1. OPERATION CHECK

a.
C435064C01
2.542,3.625 2.177,3.771 2.177,3.771 2.542,3.365 true 2.042,3.75 2.354,3.906 0.313,0.156 10 false *a
*a Retainer
V100135

Pinch
V113148

Pull off


Pinch the retainer of the No. 1 vacuum hose connector, and then pull the No. 1 vacuum hose connector off of the vacuum pump assembly.

NOTICE:

Be sure to disconnect the No. 1 vacuum hose connector by hand.



b.
C429855C01
0.281,1.292 0.281,0.875 true 1.167,0.177 1.5,0.177 true 1.573,0.104 1.75,0.281 0.177,0.177 10 true *a 0.188,1.333 0.385,1.5 0.198,0.167 10 true *b
*a Vacuum Gauge
*b Plug


Connect the hose of the vacuum gauge to the vacuum pump assembly.


c.

Start the engine and warm it up for more than 2 minutes.


d.

With the engine idling, check the vacuum of the vacuum pump assembly.

Standard Pressure:

More than 86.7 kPa (650 mmHg, 25.6 in.Hg)


If the pressure is less than the standard, disassemble and inspect the vacuum pump. If necessary, replace the vacuum pump assembly.

Click hereBrake>BRAKE SYSTEM (OTHER)>VACUUM PUMP (for TMC Made M15A-FKS)>DISASSEMBLY

HINT:

Always perform this operation check procedure after replacing or servicing the vacuum pump assembly.



e.

Remove the vacuum gauge from the vacuum pump assembly.


f.

Align the No. 1 vacuum hose connector with the vacuum pump assembly, and push them together until the No. 1 vacuum hose connector makes a "click" sound.