The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during vacuum pump assembly removal/installation are shown below.
This procedure includes the removal of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
When the cable is disconnected / reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
89661
1.REMOVE ECM
44777
2.DISCONNECT NO. 1 VACUUM HOSE CONNECTOR
| *a | Retainer |
|
Pinch |
|
Pull off |
Pinch the retainer of the No. 1 vacuum hose connector, and then pull the No. 1 vacuum hose connector off of the vacuum pump assembly.
Be sure to disconnect the No. 1 vacuum hose connector by hand.
77261D
3.SEPARATE FUEL TANK TO CANISTER TUBE
Separate the fuel tank to canister tube.
82121
4.SEPARATE ENGINE WIRE
Disconnect the 2 connectors.
Remove the 4 bolts and separate the engine wire.
Disconnect the 2 connectors.
Remove the bolt and separate the engine wire.
Disengage the clamp to separate the engine wire.
Disconnect the 6 connectors.
Disengage the 2 clamps to separate the engine wire.
Disconnect the connector.
Remove the bolt and clamp to separate the engine wire.
29300
5.REMOVE VACUUM PUMP ASSEMBLY
Using an 8 mm socket wrench, remove the 3 bolts and vacuum pump assembly from the engine assembly.
Remove the No. 1 vacuum pump O-ring from the vacuum pump assembly.