Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
87966
1.INSTALL OUTER MIRROR RETRACTOR
Install a new wire harness to a new outer mirror retractor.
Connect the connector.
Install the outer mirror retractor with the 3 screws.
Connect the connector.
Engage the guide to install the power unit assembly.
Install the 3 new screws.
Install the base with the 3 new screws.
Check that the wire harness is not caught.
Do not damage the screw coating.
Securely tighten the screws so that they will not come loose.
Engage the guides to install a new gasket.
Do not make gaps between the base and gasket.
Rotate the connector and twist the longer wire harness as shown in the illustration.
Connect each connector to a new adapter.
| *a | Paint Mark |
Install a new vinyl tape as shown in the illustration.
| Area | Measurement |
|---|---|
| A | 40 mm (1.57 in.) or more |
| B | 10 mm (0.394 in.) or more |
| *a | Paint Mark |
Install a new bar as shown in the illustration.
| Area | Measurement |
|---|---|
| A | 156 to 166 mm (6.14 to 6.54 in.) |
| B | 65 to 75 mm (2.56 to 2.95 in.) |
| C | 10 mm (0.394 in.) |
| *a | Paint Mark |
Install a new clip as shown in the illustration.
| Area | Measurement |
|---|---|
| A | 156 to 166 mm (6.14 to 6.54 in.) |
87948
2.INSTALL OUTER MIRROR HOLE COVER
Engage the claws to install a new outer mirror hole cover.
81740
3.INSTALL SIDE TURN SIGNAL LIGHT ASSEMBLY
4.INSTALL OUTER MIRROR LOWER COVER
Engage the claws to install the outer mirror lower cover.
Install the screw.
87945
5.INSTALL OUTER MIRROR COVER
87961
6.INSTALL OUTER MIRROR