1.REMOVE REAR WHEEL
48840A
2.REMOVE REAR STABILIZER LINK ASSEMBLY LH
Remove the cap.
Loosen the nut (A) of the rear stabilizer link assembly LH.
If the ball joint turns together with the nut, use a 6 mm hexagon socket wrench to hold the stud bolt.
Loosen the nut (B) of the rear stabilizer link assembly LH.
Loosen the nut with the bolt secured.
| *a | Wooden Block |
| *b | Jack |
Using a jack and a wooden block, support the rear No. 2 suspension arm assembly.
When jacking up the rear No. 2 suspension arm assembly, be sure to jack it up slowly.
Make sure to perform this operation with the vehicle kept as low as possible.
Remove the bolt, 2 nuts and rear stabilizer link assembly LH.
48830D
3.REMOVE REAR STABILIZER LINK ASSEMBLY RH
Perform the same procedure as for the LH side.
48812
4.REMOVE REAR STABILIZER BAR
Remove the 4 bolts and rear stabilizer bar from the rear suspension member sub-assembly.