Home › Drivetrain › DRIVE SHAFT / PROPELLER SHAFT › REAR DRIVE SHAFT ASSEMBLY › from 2020.09
RM36W0E _52 Drivetrain _087547 DRIVE SHAFT / PROPELLER SHAFT _0447998 REAR DRIVE SHAFT ASSEMBLY G

DRIVE SHAFT / PROPELLER SHAFT  REAR DRIVE SHAFT ASSEMBLY  INSPECTION  


PROCEDURE

Hide 1.INSPECT REAR DRIVE SHAFT ASSEMBLY

a.
C211744

Check that there is no excessive play in the radial direction of the outboard joint.


b.

Check that the inboard joint slides smoothly in the thrust direction.


c.

Check that there is no excessive play in the radial direction of the inboard joint.


d.

Check the boots for damage.


e.
C127699N10
1.438,1.521 1.656,1.74 0.219,0.219 10 (A)

Check whether each drive shaft dimension (A) is within specification.

Dimension (A):
for LH Side 739.4 to 743.4 cm (2.43 to 2.44 ft.)
for RH Side 734.4 to 738.4 cm (2.41 to 2.42 ft.)


NOTICE:

Keep the drive shaft assembly level during inspection.