Home › Drivetrain › DRIVE SHAFT / PROPELLER SHAFT › PROPELLER SHAFT ASSEMBLY › from 2020.09
RM36W0E _52 Drivetrain _087547 DRIVE SHAFT / PROPELLER SHAFT _0448000 PROPELLER SHAFT ASSEMBLY G

DRIVE SHAFT / PROPELLER SHAFT  PROPELLER SHAFT ASSEMBLY  INSPECTION  


PROCEDURE

Hide 37100 1.INSPECT PROPELLER SHAFT WITH CENTER BEARING ASSEMBLY

a.
C110958

Using a dial indicator, measure the propeller shaft runout for the front side.

Maximum Runout:

0.4 mm (0.0157 in.)


If the runout is more than the maximum, replace the propeller shaft with center bearing assembly.

NOTICE:

Place the dial indicator on the center of the shaft, and perpendicular to the shaft.



b.
C110959

Using a dial indicator, measure the propeller shaft runout for the rear side.

Maximum Runout:

0.4 mm (0.0157 in.)


If the runout is more than the maximum, replace the propeller shaft with center bearing assembly.

NOTICE:

Place the dial indicator on the center of the shaft, and perpendicular to the shaft.