Home › Drivetrain › EA67F (MANUAL TRANSMISSION / TRANSAXLE) › MANUAL TRANSAXLE SYSTEM › from 2020.09
RM36W0E _52 Drivetrain _095283 EA67F MANUAL TRANSMISSION / TRANSAXLE _0448030 MANUAL TRANSAXLE SYSTEM U

EA67F MANUAL TRANSMISSION / TRANSAXLE  MANUAL TRANSAXLE SYSTEM  DATA LIST / ACTIVE TEST  


DATA LIST


NOTICE:

In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.


HINT:

Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.


a.

Warm up the engine.


b.

Turn the ignition switch off.


c.

Connect the GTS to the DLC3.


d.

Turn the ignition switch to ON.


e.

Turn the GTS on.


f.

Enter the following menus: Powertrain / Engine / Data List.


g.

According to the display on the GTS, read the Data List.

Powertrain > Engine > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
Total Distance Traveled Total distance traveled Min.: 0 [km]
Max.: 1677215 [km]
- -
Total Distance Traveled - Unit Total Distance Traveled unit km or mile - -
Vehicle Speed Vehicle speed Min.: 0 km/h (0 mph)
Max.: 255 km/h (158 mph)
Actual vehicle speed
·

This is the current vehicle speed.

·

The vehicle speed is detected using the wheel speed sensors.

·

Vehicle speed data is delayed when it is displayed. Therefore, even if the vehicle speed listed in the freeze frame data is 0 km/h (0 mph), this does not always mean that the malfunction occurred when the vehicle was stopped.


Engine Speed Engine speed Min.: 0 rpm
Max.: 16383 rpm
950 to 1050 rpm: Idling (shift state neutral, engine warmed up and A/C off) When the crankshaft position sensor is malfunctioning, "Engine Speed" is approximately 0 rpm or varies greatly from the actual engine speed.
Mass Air Flow Sensor Airflow rate from mass air flow meter sub-assembly Min.: 0 gm/sec
Max.: 2047.96 gm/sec
·

2.5 to 4.5 gm/sec: Idling (engine warmed up)

·

3.0 to 7.0 gm/sec: 2000 rpm (without load)

·

6.0 to 12.0 gm/sec: 3000 rpm (without load)


This is the intake air amount measured by the mass air flow meter sub-assembly.
Intake Manifold Absolute Pressure Intake manifold absolute pressure Min.: 0 kPa (0 psi)
Max.: 2047.96 kPa (296.95 psi)
·

80 to 110 kPa (11.6 to 15.95 psi): Engine switch on (IG)

·

20 to 40 kPa (2.9 to 5.8 psi): Idling with warmed up engine


This is the intake manifold pressure.
Intake Manifold Absolute Pressure Supported Status of the Intake Manifold Absolute Pressure Supported Supp or Unsupp Supp -
Coolant Temperature Engine coolant temperature Min.: -40°C (-40°F)
Max.: 140°C (284°F)
75 to 100°C (167 to 212°F): After warming up This is the engine coolant temperature.
BATT Voltage Battery voltage Min.: 0.000 V
Max.: 79.998 V
11 to 14 V: Engine idling -
Throttle Motor Duty Ratio Throttle actuator Min.: 0%
Max.: 100%
0 to 22%: Idling with warmed up engine (A/C off and shift state neutral) This is the output duty ratio of the throttle actuator drive circuit.
Starter SW Starter signal ON or OFF
·

ON: Starter operating

·

OFF: Starter not operating


-
Neutral Position SW Neutral position switch status ON or OFF ON: Clutch pedal depressed -
Stop Light SW Stop light switch status ON or OFF
·

ON: Brake pedal depressed

·

OFF: Brake pedal released


-
Cruise Main SW Cruise control switch status ON or OFF - -
NIM Sensor Speed Input shaft speed (NIM) Min.: 0 rpm
Max.: 16383 rpm
Input shaft speed (NIM) equal to engine speed (NE): Clutch pedal not depressed, vehicle running -
NIM Sensor Voltage Transmission revolution sensor (NIM) output voltage Min.: 0.000 V
Max.: 4.999 V
0.2 to 1.8 V: Engine idling (Vehicle stopped with shift lever in Neutral) -
Shift SW Status (R Range) Back-up light switch status ON or OFF
·

ON: Shift lever in R

·

OFF: Shift lever not in R


-
Clutch Stroke Position Clutch stroke calculated by ECM Min.: -200.0%
Max.: 199.9%
Value increases: Clutch pedal released → clutch pedal fully depressed -
Clutch Stroke Sensor Voltage Clutch stroke sensor output voltage Min.: 0.000 V
Max.: 4.999 V
Value increases: Clutch pedal released → clutch pedal fully depressed -
M/T Oil Temperature Manual transaxle oil temperature sensor value Min.: -40°C (-40°F)
Max.: 215.9°C (420.62°F)
- If the value is -40°C (-40°F) or 215.9°C (420.62°F) or more, the manual transaxle oil temperature sensor circuit is open or shorted.
iMT SW iMT switch assembly (Combination switch assembly) status ON or OFF
·

ON: iMT switch assembly (Combination switch assembly) being pushed

·

OFF: iMT switch assembly (Combination switch assembly) not being pushed


-
iMT Telltale iMT telltale display request OFF, Green or Yellow
·

OFF: iMT system off

·

Green: iMT system stand-by

·

Yellow: iMT system malfunction, indicator light initial check


-