Home › Vehicle Interior › METER / GAUGE / DISPLAY › METER / GAUGE SYSTEM › 2020.09–2021.11
RM36W0E _58 Vehicle Interior _087985 METER / GAUGE / DISPLAY _0420292 METER / GAUGE SYSTEM G

METER / GAUGE / DISPLAY  METER / GAUGE SYSTEM  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.INSPECT SPEEDOMETER (for 5 Door)

NOTICE:
·

The combination meter assembly receives the vehicle speed signal from the skid control ECU (brake booster with master cylinder assembly)*1 or skid control ECU (brake actuator assembly)*2 via CAN communication. Therefore, perform the following inspection referring to values on the Data List of the skid control ECU (brake booster with master cylinder assembly)*1 or skid control ECU (brake actuator assembly)*2 because it is the source of the vehicle speed signal.

·

Data List values of the skid control ECU (brake booster with master cylinder assembly)*1 or skid control ECU (brake actuator assembly)*2 are used for this inspection. Therefore, make sure to perform this inspection after confirming that DTCs are not output.

·

If the tire size or tire inflation pressure is not within the specified range, or the tires are excessively worn, the speedometer indication error will increase. Therefore, make sure to perform this inspection after checking that the tire size, tire inflation pressure and tire wear are in the specified range.


*1: for TMC Made HV Model

*2: except TMC Made HV Model



a.

Warm up the engine.


b.

Read the Data List according to the display on the GTS.

Chassis > Brake > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
Vehicle Speed Maximum wheel speed sensor Min.: 0 km/h (0 mph), Max.: 326.4 km/h (203 mph) Vehicle stopped: 0 km/h (0 mph) When driving at constant speed: No large fluctuations
Chassis > Brake > Data List
Tester Display
Vehicle Speed
50003 435 36
Reference km/h (for TMC Made):
GTS Indication (km/h) Acceptable Range (km/h)
20 20.5 to 23.5
40 41.1 to 44.1
60 61.6 to 64.6
80 82.2 to 84.2
100 102.7 to 104.7
120 123.3 to 125.3
140 143.8 to 146.8
160 164.4 to 167.4
180 184.9 to 187.9
200 205.5 to 208.5
220 226.0 to 229.0

Reference km/h (for TMMF Made):
GTS Indication (km/h) Acceptable Range (km/h)
20 20.6 to 23.6
40 41.3 to 44.3
60 61.9 to 64.9
80 82.5 to 84.5
100 103.1 to 105.1
120 123.8 to 125.8
140 144.4 to 147.4
160 165.0 to 168.0
180 185.6 to 188.6
200 206.3 to 209.3
220 226.9 to 229.9

Reference mph:
GTS Indication (mph) Acceptable Range (mph)
20 20.6 to 23.1
40 41.3 to 43.8
60 61.9 to 65.4
80 82.5 to 86.5
100 103.1 to 107.6
120 123.8 to 128.7
140 144.4 to 149.7

OK:

Speedometer reading is within the acceptable range at each vehicle speed.



Hide 2.INSPECT SPEEDOMETER (for 3 Door)

NOTICE:
·

The combination meter assembly receives the vehicle speed signal from the skid control ECU (brake actuator assembly) via CAN communication. Therefore, perform the following inspection referring to values on the Data List of the skid control ECU (brake actuator assembly) because it is the source of the vehicle speed signal.

·

Data List values of the skid control ECU (brake actuator assembly) are used for this inspection. Therefore, make sure to perform this inspection after confirming that DTCs are not output.

·

If the tire size or tire inflation pressure is not within the specified range, or the tires are excessively worn, the speedometer indication error will increase. Therefore, make sure to perform this inspection after checking that the tire size, tire inflation pressure and tire wear are in the specified range.



a.

Warm up the engine.


b.

Read the Data List according to the display on the GTS.

Chassis > Brake > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
Vehicle Speed Maximum wheel speed sensor Min.: 0 km/h (0 mph), Max.: 326.4 km/h (203 mph) Vehicle stopped: 0 km/h (0 mph) When driving at constant speed: No large fluctuations
Chassis > Brake > Data List
Tester Display
Vehicle Speed
50003 435 36
Reference km/h:
GTS Indication (km/h) Acceptable Range (km/h)
20 20.5 to 23.5
40 41.0 to 44.0
60 61.5 to 64.5
80 82.0 to 84.4
100 102.6 to 105.0
120 123.1 to 125.5
140 143.86 to 146.6
160 164.1 to 167.1
180 184.6 to 187.6
200 205.1 to 208.1
220 225.6 to 228.6

Reference mph:
GTS Indication (mph) Acceptable Range (mph)
20 20.5 to 23.0
40 41.0 to 43.5
60 61.5 to 65.0
80 82.0 to 86.0
100 102.6 to 107.1
120 123.1 to 128.0
140 143.6 to 148.9

OK:

Speedometer reading is within the acceptable range at each vehicle speed.



Hide 3.INSPECT TACHOMETER

a.

Warm up the engine.


b.

Read the Data List according to the display on the GTS.

Powertrain > Engine > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
Engine Speed Engine speed - Engine stopped: 0 rpm
While engine running at a constant speed: No significant fluctuation
-
Powertrain > Engine > Data List
Tester Display
Engine Speed
50003 372 211
Reference (for TMC Made 5 Door):
GTS Indication (rpm) Acceptable Range (rpm)
Data in ( ) is for Reference
700 630 to 770
1000 (900 to 1100)
2000 (1850 to 2150)
3000 2800 to 3200
4000 (3800 to 4200)
5000 4800 to 5000
6000 (5750 to 6000)

Reference (except TMC Made 5 Door):
GTS Indication (rpm) Acceptable Range (rpm)
Data in ( ) is for Reference
700 630 to 770
1000 (900 to 1100)
2000 (1850 to 2150)
3000 2800 to 3200
4000 (3800 to 4200)
5000 4800 to 5200
6000 (5750 to 6250)

OK:

Tachometer reading is within the acceptable range at each engine speed.



Hide 4.INSPECT WARNING AND INDICATOR LIGHT ILLUMINATION (INITIAL CHECK)

a.

Turn the ignition switch off.


b.

Turn the ignition switch to ON or ON (READY), and check the operation of the warning and indicator lights in the following table.

OK:

All of the lights illuminate and then turn off

Warning or Indicator Light
Brake warning light / red (malfunction)
Brake warning light / yellow (minor malfunction)
SRS warning light
EPS warning light
MIL (Check engine warning light)
PCS warning light
Automatic high beam indicator light
Slip indicator light
VSC OFF indicator light
ABS warning light
Eco driving indicator light
PKSB OFF indicator light
Tire pressure warning light
Stop and start indicator light
BSM indicator light


HINT:

The illumination of each warning light and indicator light varies.