1.REMOVE CYLINDER BOOT
| *1 | Cylinder Boot |
| *2 | Retainer |
| *a | Protective Tape |
Using a screwdriver with its tip wrapped with protective tape, remove the 4 cylinder boots from the front disc brake cylinder.
Do not forcefully pry off the retainer.
Be careful not to damage the front disc brake cylinder.
47731
2.REMOVE FRONT DISC BRAKE PISTON
| *a | Wooden Block |
Install a wooden block between the pistons of the front disc brake cylinder to stop them coming out.
Using an air gun, gradually apply compressed air until the 4 front disc brake pistons touch the wooden block.
Do not insert your hand between the pistons to hold the front disc brake cylinder.
When compressed air is blown in, the front disc brake piston may jump out quickly and trap your fingers.
Do not allow any brake fluid to spatter.
Remove the wooden block.
Remove the 4 front disc brake pistons from the front disc brake cylinder.
3.REMOVE PISTON SEAL
| *a | Protective Tape |
Using a screwdriver with its tip wrapped with protective tape, remove the 4 piston seals from the front disc brake cylinder.
Do not damage the cylinder bore and the seal groove.
31478B
4.REMOVE FRONT DISC BRAKE BLEEDER PLUG CAP
Remove the front disc brake bleeder plug cap from the front disc brake bleeder plug.
47547B
5.REMOVE FRONT DISC BRAKE BLEEDER PLUG
Remove the front disc brake bleeder plug from the front disc brake cylinder.