1.REMOVE CYLINDER BOOT
| *1 | Cylinder Boot |
| *2 | Retainer |
| *a | Protective Tape |
Using a screwdriver with its tip wrapped with protective tape, remove the 2 cylinder boots from the rear disc brake cylinder.
Do not forcefully pry off the retainer.
Be careful not to damage the rear disc brake cylinder.
47831
2.REMOVE REAR DISC BRAKE PISTON
| *a | Wooden Block |
Install a wooden block between the pistons of the rear disc brake cylinder to stop them coming out.
Using an air gun, gradually apply compressed air until the 2 rear disc brake pistons touch the wooden block.
Do not insert your hand between the pistons to hold the rear disc brake cylinder.
When compressed air is blown in, the rear disc brake piston may jump out quickly and trap your fingers.
Do not allow any brake fluid to spatter.
Remove the wooden block.
Remove the 2 rear disc brake pistons from the rear disc brake cylinder.
3.REMOVE PISTON SEAL
| *a | Protective Tape |
Using a screwdriver with its tip wrapped with protective tape, remove the 2 piston seals from the rear disc brake cylinder.
Do not damage the cylinder bore and the seal groove.
31478C
4.REMOVE REAR DISC BRAKE BLEEDER PLUG CAP
Remove the rear disc brake bleeder plug cap from the rear disc brake bleeder plug.
47547C
5.REMOVE REAR DISC BRAKE BLEEDER PLUG
Remove the rear disc brake bleeder plug from the rear disc brake cylinder.