Home › Brake › BRAKE (REAR) › REAR BRAKE (for 2-Pot Caliper) › from 2020.09
RM36W0E _54 Brake _089429 BRAKE (REAR) _0448438 REAR BRAKE(for 2-Pot Caliper) A

BRAKE (REAR)  REAR BRAKE(for 2-Pot Caliper)  REASSEMBLY  


PROCEDURE

Hide 47547C 1.TEMPORARILY TIGHTEN REAR DISC BRAKE BLEEDER PLUG

a.

Temporarily tighten the rear disc brake bleeder plug to the rear disc brake cylinder.

HINT:

Fully tighten the rear disc brake bleeder plug after bleeding the system.



Hide 31478C 2.INSTALL REAR DISC BRAKE BLEEDER PLUG CAP

a.

Install the rear disc brake bleeder plug cap to the rear disc brake bleeder plug.


Hide 3.INSTALL PISTON SEAL

a.
C336938C11
0,0 0,0 false
V100155

Lithium Soap Base Glycol Grease


Apply lithium soap base glycol grease to the entire circumference of 2 new piston seals.


b.
C447982

Install the 2 piston seals to the rear disc brake cylinder.

NOTICE:
·

Securely install the piston seal into the groove of the rear disc brake cylinder.

·

Do not damage the piston seal.




Hide 4.INSTALL CYLINDER BOOT

a.
C447979C01
0,0 0,0 false
V100155

Lithium Soap Base Glycol Grease


Apply a light layer of lithium soap base glycol grease to the inner surfaces of 2 new cylinder boots.


b.

Apply a light layer of lithium soap base glycol grease to the contact surfaces of the 2 rear disc brake pistons.


c.
C447980

Install the 2 cylinder boots to the 2 rear disc brake pistons.

NOTICE:

Securely install the cylinder boot into the groove of the rear disc brake piston.



Hide 47831 5.INSTALL REAR DISC BRAKE PISTON

a.
C447975

Install the 2 rear disc brake pistons to the rear disc brake cylinder.

NOTICE:

Do not forcibly install the rear disc brake piston into the rear disc brake cylinder.



b.
C447976C01
2.958,0.979 2.771,1.167 false 2.667,1.406 2.667,1.813 false 3,0.875 3.313,1.031 0.313,0.156 10 false *1 2.594,1.833 2.906,1.99 0.313,0.156 10 false *2
*1 Cylinder Boot
*2 Retainer


Push in the 2 cylinder boots and engage the 2 cylinder boots to each retainer of the rear disc brake cylinder.

NOTICE:
·

Securely install the cylinder boot into the groove of the rear disc brake cylinder.

·

Do not damage the cylinder boot.