Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
47319F
1.INSTALL REAR FLEXIBLE HOSE
When installing the rear flexible hose, minimize twisting of the hose.
| *a | Identification Mark |
| *b | Torque Wrench Fulcrum Length |
Install the rear flexible hose with a new clip.
When installing the rear flexible hose, face the identification mark to the upper side of the vehicle.
Install the clip as far as it will go.
Using a union nut wrench, connect the brake line to the rear flexible hose while holding the rear flexible hose with a wrench.
Do not kink or damage the brake line.
Do not allow any foreign matter such as dirt or dust to enter the brake line from the connecting parts.
Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
When using a union nut wrench (fulcrum length of 22 mm (0.866 in.)) + torque wrench (fulcrum length of 162 mm (6.38 in.)):
13.4 N*m (137 kgf*cm, 10 ft.*lbf)
Install the rear flexible hose to the flexible hose bracket with the bolt.
Do not twist the rear flexible hose when installing it.
Connect the rear flexible hose to the rear disc brake cylinder assembly with a new union bolt and a new gasket.
Install the rear flexible hose lock securely into the lock hole in the rear disc brake cylinder assembly.
Do not twist the rear flexible hose when installing it.
2.BLEED BRAKE LINE
3.INSTALL REAR WHEEL