23250E
1.INSPECT FUEL INJECTOR ASSEMBLY
This inspection is for checking the fuel injector assembly for an open or short. Because the fuel injector assembly of this vehicle is a high-pressure type, fuel injection volume cannot be checked.
| *a | Component without harness connected
(Fuel Injector Assembly) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| F10-1 - F10-2 | 20°C (68°F) | 1.34 to 1.64 Ω |
| F11-1 - F11-2 | 20°C (68°F) | 1.34 to 1.64 Ω |
| F12-1 - F12-2 | 20°C (68°F) | 1.34 to 1.64 Ω |
If the result is not as specified, replace the fuel injector assembly.