Home › Engine / Hybrid System › G16E-GTS (STARTING) › ENGINE SWITCH › from 2020.09
RM36W0E _51 Engine / Hybrid System _095693 G16E-GTS STARTING _0449405 ENGINE SWITCH G

G16E-GTS STARTING  ENGINE SWITCH  INSPECTION  


PROCEDURE

Hide 89611 1.INSPECT ENGINE SWITCH

a.

Check the resistance.

i.
A430843C03
1.469,0.146 1.917,0.396 0.448,0.25 1.865,0.948 2.323,0.281 2.323,0.281 2.521,0.281 true 1.167,1.333 0.771,1.333 true 1.438,1.75 1.438,1.344 true 1.167,0.969 0.771,0.969 true 0.104,0.094 0.417,0.25 0.313,0.156 10 false *a 2.635,0.177 3.344,0.5 0.708,0.323 10 false GND 0.479,1.25 1.01,1.5 0.531,0.25 10 false SS1 0.469,0.875 1,1.125 0.531,0.25 10 false SS2 1.323,1.75 1.854,2 0.531,0.25 10 false SS3 1.563,0.177 2.271,0.5 0.708,0.323 10 false H68
*a Component without harness connected
(Engine Switch)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
H68-12(SS1) - H68-3(GND)
H68-6(SS2) - H68-3(GND)
H68-11(SS3) - H68-3(GND)
Not pushed 10 kΩ or higher
Pushed Below 1 Ω


If the result is not as specified, replace the engine switch.



b.

Check the LED illumination.

i.
A430843C04
1.563,0.188 1.979,0.448 0.417,0.26 1.885,0.958 2.531,0.479 2.531,0.479 2.677,0.479 true 1.385,0.969 0.958,0.448 0.958,0.448 0.813,0.448 true 2.75,0.417 3.365,0.615 0.615,0.198 10 false GND 0.396,0.375 1.01,0.573 0.615,0.198 10 false SWIL 0.104,0.073 0.719,0.271 0.615,0.198 10 false *a 1.656,0.24 2.271,0.438 0.615,0.198 10 false H68
*a Component without harness connected
(Engine Switch)


Apply battery voltage between the terminals of the engine switch and check the illumination condition of the engine switch indicator light.

OK:
Tester Connection Condition Specified Condition
H68-5(SWIL) - H68-3(GND) H68-5(SWIL) - Auxiliary battery positive (+)
H68-3(GND) - Auxiliary battery negative (-)
Illuminates


HINT:
·

If the positive (+) lead and the negative (-) lead are incorrectly connected, the engine switch indicator light will not illuminate.

·

If the voltage is too low, the engine switch indicator light will not illuminate.



If the result is not as specified, replace the engine switch.