Home › General › SPECIFICATIONS › G16E-GTS STARTING › from 2020.09
RM36W0E _V1 General _087262 SPECIFICATIONS _0449409 G16E-GTS STARTING F

SPECIFICATIONS  G16E-GTS STARTING  SERVICE DATA  


Starter Assembly
Tester Connection Condition Specified Condition
Battery positive (+) terminal - Terminal 30 - Terminal 50 11.5 V Below 100 A

Starter Armature Assembly
Tester Connection Condition Specified Condition
Segment - Segment Always Below 1 Ω
Segment - Starter armature core 10 kΩ or higher

Commutator runout Maximum runout 0.05 mm (0.00197 in.)

Commutator diameter Standard diameter 29.0 mm (1.1417 in.)
Minimum diameter 28.0 mm (1.1024 in.)

Undercut depth Standard undercut depth 0.7 mm (0.0276 in.)
Minimum undercut depth 0.4 mm (0.0157 in.)

Starter Brush Holder Assembly
Brush length Standard length 14.4 mm (0.567 in.)
Minimum length 9.0 mm (0.354 in.)

Tester Connection Condition Specified Condition
A - B
A - C
B - D
C - D
Always 10 kΩ or higher
A - D
B - C
Below 1 Ω

Brush spring load Standard spring load 16.2 to 19.8 N (1.65 to 2.02 kgf, 3.64 to 4.45 lbf)
Minimum spring load 6.7 N (0.68 kgf, 1.5 lbf)

Magnet start switch assembly
Tester Connection Condition Specified Condition
Terminal 50 - Terminal C Always Below 1 Ω
Terminal 50 - Magnet starter switch assembly body Always Below 2 Ω

Engine Switch
Tester Connection Condition Specified Condition
H68-12(SS1) - H68-3(GND)
H68-6(SS2) - H68-3(GND)
H68-11(SS3) - H68-3(GND)
Not pushed 10 kΩ or higher
Pushed Below 1 Ω

Tester Connection Condition Specified Condition
H68-5(SWIL) - H68-3(GND) H68-5(SWIL) - Auxiliary battery positive (+)
H68-3(GND) - Auxiliary battery negative (-)
Illuminates

Ignition or Starter Switch Assembly
Tester Connection Condition Specified Condition
Between all terminals LOCK 10 kΩ or higher
H54-6 (ACC) - H54-7 (AM1) ACC Below 1 Ω
H54-6 (ACC) - H54-7 (AM1) - H54-8 (IG1) ON Below 1 Ω
H54-1 (AM2) - H54-2 (IG2)
H54-5 (ST1) - H54-7 (AM1) - H54-8 (IG1) START Below 1 Ω
H54-1 (AM2) - H54-2 (IG2) - H54-4 (ST2)

ST No. 1 Relay
Tester Connection Condition Specified Condition
3 - 5 Battery voltage not applied to terminals 1 and 2 10 kΩ or higher
Battery voltage applied to terminals 1 and 2 Below 1 Ω