Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › TOYOTA PARKING ASSIST-SENSOR SYSTEM (w/o Parking Support Brake System) › 2020.09–2021.04
RM36W0E _56 Audio / Visual / Telematics _088657 PARK ASSIST / MONITORING _0449590 TOYOTA PARKING ASSIST-SENSOR SYSTEM(w/o Parking Support Brake System) D

PARK ASSIST / MONITORING  TOYOTA PARKING ASSIST-SENSOR SYSTEM(w/o Parking Support Brake System)  CALIBRATION  


NOTICE:

When any of the following parts have been replaced, perform adjustment shown in the following table. If not, the TOYOTA parking assist-sensor system may not operate correctly.


ADJUST TOYOTA PARKING ASSIST-SENSOR SYSTEM


a.

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during TOYOTA parking assist-sensor system removal/installation are shown below.

Part Name Operation Adjustment Item Proceed to
Clearance warning ECU assembly Replacement Bumper type registration Procedure 1
Ultrasonic sensor Initialization of ultrasonic sensors



REGISTRATION (PROCEDURE 1)


a.

Preparation

i.

Check for DTCs.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>TOYOTA PARKING ASSIST-SENSOR SYSTEM (w/o Parking Support Brake System)>DTC CHECK / CLEAR

NOTICE:

If DTC C1AE187, C1AE287, C1AE387, C1AE487, C1AE687, C1AE787, C1AE887 or C1AE987 are output, continue with the registration procedure.




b.

Connect the GTS to the DLC3.


c.

Turn the ignition switch to ON.


d.

Turn the GTS on.


e.

Enter the following menus: Body Electrical / Clearance Warning / Utility.

Body Electrical > Clearance Warning > Utility
Tester Display
ECU Calibration
50005 438 2535

f.

According to the display on the GTS, perform calibration.


g.

Enter the bumper type using the GTS.

Bumper Type Value
Standard type 1

HINT:

If the clearance warning ECU assembly is replaced or removed and installed, it is necessary to perform bumper type registration.