Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › TOYOTA PARKING ASSIST-SENSOR SYSTEM (w/o Parking Support Brake System) › 2020.09–2021.04
RM36W0E _56 Audio / Visual / Telematics _088657 PARK ASSIST / MONITORING _0449590 TOYOTA PARKING ASSIST-SENSOR SYSTEM(w/o Parking Support Brake System) J

PARK ASSIST / MONITORING  TOYOTA PARKING ASSIST-SENSOR SYSTEM(w/o Parking Support Brake System)  Clearance Warning ECU Power Source Circuit  


DESCRIPTION

This circuit provides power to operate the clearance warning ECU assembly.

WIRING DIAGRAM

E434448E02
5.313,1.729 5.688,1.906 0.375,0.177 10 false O60 5.313,1.906 6.823,2.302 1.51,0.396 10 false Clearance Warning ECU Assembly 5.583,1.302 5.74,1.5 0.156,0.198 10 false E 5.281,1.156 5.594,1.354 0.313,0.198 10 false 31 5.344,0.438 5.656,0.635 0.313,0.198 10 false 1 5.583,0.583 5.896,0.781 0.313,0.198 10 false IG 0.719,0.563 2.719,0.792 2,0.229 10 false from Engine Stop and Start ECU

CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuses for circuits related to this system before performing the following procedure.


PROCEDURE

1.CHECK HARNESS AND CONNECTOR (CLEARANCE WARNING ECU ASSEMBLY - BATTERY AND BODY GROUND)
a.

Disconnect the O60 clearance warning ECU assembly connector.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
O60-31 (E) - Body ground Always Below 1 Ω



c.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Switch Condition Specified Condition
O60-1 (IG) - Body ground Ignition switch ON 10.5 to 16V
O60-1 (IG) - Body ground Ignition switch off Below 1 V



Result:
Proceed to
OK
NG



OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR