84210
1.INSPECT BACK-UP LIGHT SWITCH ASSEMBLY
| *a | Push |
| *b | Release |
| *c | Component without harness connected
(Back-up Light Switch Assembly) |
Measure the resistance according to the values in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| D48-1(RL) - D48-2(RB) | Pushed | Below 1 Ω |
| D48-1(RL) - D48-2(RB) | Released | 10 kΩ or higher |
If the result is not as specified, replace the back-up light switch assembly.