Home › General › MAINTENANCE › DIFFERENTIAL OIL › from 2020.09
RM36W0E _V1 General _088300 MAINTENANCE _0449711 DIFFERENTIAL OIL A

MAINTENANCE  DIFFERENTIAL OIL  REPLACEMENT  


CAUTION / NOTICE / HINT

HINT:

Stop the vehicle on a level surface.


PROCEDURE

Hide 1.DRAIN DIFFERENTIAL OIL

NOTICE:
·
C440353

Do not loosen the bolt shown in the illustration to drain the differential oil.

·

Doing so could cause differential oil to spill onto the tail exhaust pipe assembly.



a.
C440354

Using a 10 mm socket hexagon wrench, remove the rear differential filler plug and gasket.


b.
C440355

Using a 10 mm socket hexagon wrench, remove the rear differential drain plug and gasket to drain the differential oil.

NOTICE:

As the differential oil may be hot after driving, make sure that the differential is sufficiently cool before starting work.



c.

Using a 10 mm socket hexagon wrench, install a new gasket and the rear differential drain plug.

Torque:
39 N*m (398 kgf*cm, 29 ft.*lbf)


Hide 2.ADD DIFFERENTIAL OIL

a.

Add differential oil.

Oil Type:

Toyota Genuine Differential gear oil LX 75W-85 GL-5 or equivalent


Standard Differential Oil Capacity:

0.45 to 0.55 liters (0.48 to 0.58 US qts., 0.40 to 0.48 Imp. qts.)


NOTICE:
·

Using differential gear oil other than the specified oil may cause abnormal noise or vibration, or damage the differential gear of your vehicle.

·

Add the differential oil in small quantities every few minutes.

·

Too much or too little oil will lead to differential problems.




b.
C279600C01
1.219,0.99 1.531,1.188 0.313,0.198 10 *a
*a 0 to 5 mm (0 to 0.196 in.)


Check that the oil level is between 0 to 5 mm (0 and 0.196 in.) from the bottom lip of the rear differential filler plug opening.


c.

Inspect for oil leaks if the oil level is low.


d.
C440354

Using a 10 mm socket hexagon wrench, install a new gasket and the rear differential filler plug.

Torque:
39 N*m (398 kgf*cm, 29 ft.*lbf)

NOTICE:

After changing the oil, drive the vehicle and then check the oil level again.



Hide 3. INSPECT FOR DIFFERENTIAL OIL LEAK