CHECK STEREO COMPONENT EQUALIZER ASSEMBLY (w/ STEREO COMPONENT AMPLIFIER ASSEMBLY)
| Terminal No. (Symbol) | Terminal Description | Condition | Specified Condition |
|---|---|---|---|
| O124-14(+B) - O124-28(GND) | Power source | Always | 11 to 14 V |
| O124-27(IGN) - O124-28(GND) | Power source (IG) | Ignition switch ON | 11 to 14 V |
| O124-13(ACC) - O124-28(GND) | Power source (ACC) | Ignition switch ACC | 11 to 14 V |
| O124-28(GND) - Body ground | Ground | Always | Below 1 Ω |
| O124-7(MC1+) - O124-28(GND) | Active noise control microphone input signal | Active noise control microphone LH tapped with finger | Pulse generation |
| O124-21(MC1-) - O124-28(GND) | Active noise control microphone input signal | Always | Below 1 Ω |
| O124-6(MC2+) - O124-28(GND) | Active noise control microphone input signal | Active noise control microphone RH tapped with finger | Pulse generation |
| O124-20(MC2-) - O124-28(GND) | Active noise control microphone input signal | Always | Below 1 Ω |
| O124-3(NEI) - O124-28(GND) | Engine pulse signal | Idling with warm engine | Pulse generation
(See waveform 1) |
| O124-12(CH1+) - O124-28(GND) | Active noise control microphone output signal | Active noise control system operating | Pulse generation |
| O124-26(CH1-) - O124-28(GND) | Active noise control microphone output signal | Active noise control system operating | Pulse generation |
| O124-11(CH2+) - O124-28(GND) | Active noise control microphone output signal | Active noise control system operating | Pulse generation |
| O124-25(CH2-) - O124-28(GND) | Active noise control microphone output signal | Active noise control system operating | Pulse generation |
| O124-10(CH3+) - O124-28(GND) | Active noise control microphone output signal | Active noise control system operating | Pulse generation |
| O124-24(CH3-) - O124-28(GND) | Active noise control microphone output signal | Active noise control system operating | Pulse generation |
| O124-8(CH4+) - O124-28(GND) | Active noise control microphone output signal | Active noise control system operating | Pulse generation |
| O124-22(CH4-) - O124-28(GND) | Active noise control microphone output signal | Active noise control system operating | Pulse generation |
| O124-17(ACNT) - O124-28(GND) | Active noise control microphone output signal | Active noise control system not operating | Below 1 V |
| Active noise control system operating | 4.5 V or higher | ||
| O124-2(ACK1) | Serial communication (UART) signal | - | - |
| O124-16(ACK2) | Serial communication (UART) signal | - | - |
| O124-1(CANH) | CAN communication signal | - | - |
| O124-15(CANL) | CAN communication signal | - | - |
Waveform 1
The oscilloscope waveform shown in the illustration is an example for reference only. The waveform fluctuates according to engine speed.
| Item | Condition |
|---|---|
| Measurement terminal | O124-3 (NEI) - O124-28 (GND) |
| Tool setting | 5 V/DIV., 20 ms./DIV. |
| Vehicle condition | Idling with warm engine |
CHECK STEREO COMPONENT EQUALIZER ASSEMBLY (w/o STEREO COMPONENT AMPLIFIER ASSEMBLY)
| Terminal No. (Symbol) | Terminal Description | Condition | Specified Condition |
|---|---|---|---|
| O131-15(+B) - O131-30(GND) | Power source | Always | 11 to 14 V |
| O131-29(IGP) - O131-30(GND) | Power source (IG) | Ignition switch ON | 11 to 14 V |
| O131-14(ACC) - O131-30(GND) | Power source (ACC) | Ignition switch ACC | 11 to 14 V |
| O131-30(GND) - Body ground | Ground | Always | Below 1 Ω |
| O132-1(MC1+) - O131-30(GND) | Active noise control microphone input signal | Active noise control microphone LH tapped with finger | Pulse generation |
| O132-5(MC1-) - O131-30(GND) | Active noise control microphone input signal | Always | Below 1 Ω |
| O132-2(MC2+) - O131-30(GND) | Active noise control microphone input signal | Active noise control microphone RH tapped with finger | Pulse generation |
| O132-6(MC2-) - O131-30(GND) | Active noise control microphone input signal | Always | Below 1 Ω |
| O131-3(NEI) - O131-30(GND) | Engine pulse signal | Idling with warm engine | Pulse generation
(See waveform 1) |
| O131-24(FLI-) - O131-30(GND) | Active noise control microphone output signal | Active noise control system operating | Pulse generation |
| O131-9(FLI+) - O131-30(GND) | Active noise control microphone output signal | Active noise control system operating | Pulse generation |
| O131-23(FRI-) - O131-30(GND) | Active noise control microphone output signal | Active noise control system operating | Pulse generation |
| O131-8(FRI+) - O131-30(GND) | Active noise control microphone output signal | Active noise control system operating | Pulse generation |
| O131-5(RRI+) - O131-30(GND) | Active noise control microphone output signal | Active noise control system operating | Pulse generation |
| O131-20(RRI-) - O131-30(GND) | Active noise control microphone output signal | Active noise control system operating | Pulse generation |
| O131-6(RLI+) - O131-30(GND) | Active noise control microphone output signal | Active noise control system operating | Pulse generation |
| O131-21(RLI-) - O131-30(GND) | Active noise control microphone output signal | Active noise control system operating | Pulse generation |
| O131-7(ASG1) | Shield ground | - | - |
| O131-22(ASG2) | Shield ground | - | - |
| O131-12(FR+) - O131-30(GND) | Sound signal | Active noise control system operating | Pulse generation |
| O131-27(FR-) - O131-30(GND) | Sound signal | Active noise control system operating | Pulse generation |
| O131-13(FL+) - O131-30(GND) | Sound signal | Active noise control system operating | Pulse generation |
| O131-28(FL-) - O131-30(GND) | Sound signal | Active noise control system operating | Pulse generation |
| O131-10(RR+) - O131-30(GND) | Sound signal | Active noise control system operating | Pulse generation |
| O131+25(RR-) - O131-30(GND) | Sound signal | Active noise control system operating | Pulse generation |
| O131-11(RL+) - O131-30(GND) | Sound signal | Active noise control system operating | Pulse generation |
| O131-28(RL-) - O131-30(GND) | Sound signal | Active noise control system operating | Pulse generation |
| O131-1(CANH) | CAN communication signal | - | - |
| O131-16(CANL) | CAN communication signal | - | - |
Waveform 1
The oscilloscope waveform shown in the illustration is an example for reference only. The waveform fluctuates according to engine speed.
| Item | Condition |
|---|---|
| Measurement terminal | O131-3 (NEI) - O131-28 (GND) |
| Tool setting | 5 V/DIV., 20 ms./DIV. |
| Vehicle condition | Idling with warm engine |
STEREO COMPONENT AMPLIFIER ASSEMBLY
Click hereAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM>TERMINALS OF ECU