This DTC is stored when an UART communication error occurs between the stereo component equalizer assembly and stereo component amplifier assembly.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| B1AA187 | UART Communication Between ANC and Audio Amplifier Missing Message | Stereo component equalizer assembly detects a UART communication malfunction in stereo component amplifier assembly for 4 seconds or more continuously* | ·
Harness or connector ·
Stereo component amplifier assembly ·
Stereo component equalizer assembly |
*: Malfunction monitoring is not performed under the following conditions, in order to prevent erroneous detection.
After ignition switch is turned to ACC for 3 seconds or more.
After the auxiliary battery voltage returns to normal for 3 seconds.
Before 3 seconds have elapsed after auxiliary battery voltage has returned to normal.
Clear the DTCs.
| Proceed to |
|---|
| NEXT |
NEXT
Check for DTCs.
| Result | Proceed to |
|---|---|
| DTC B1AA187 is not output | A |
| DTC B1AA187 is output | B |
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B
Disconnect the O124 stereo component equalizer assembly connector.
Disconnect the O123 stereo component amplifier assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| O124-2 (ACK1) - O123-2 (ACK1) | Always | Below 1 Ω |
| O124-16 (ACK2) - O123-10 (ACK2) | Always | Below 1 Ω |
| O124-2 (ACK1) - Body ground | Always | 10 kΩ or higher |
| O124-16 (ACK2) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Replace the stereo component amplifier assembly with a new or known good one.
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>STEREO COMPONENT AMPLIFIER>REMOVAL
| Proceed to |
|---|
| NEXT |
NEXT
Clear the DTCs.
| Proceed to |
|---|
| NEXT |
NEXT
Check for DTCs.
| Result | Proceed to |
|---|---|
| DTC B1AA187 is not output | A |
| DTC B1AA187 is output | B |
A
B