Home › Audio / Visual / Telematics › AUDIO / VIDEO › ACTIVE NOISE CONTROL SYSTEM › from 2020.09
RM36W0E _56 Audio / Visual / Telematics _088597 AUDIO / VIDEO _0449775 ACTIVE NOISE CONTROL SYSTEM C

AUDIO / VIDEO  ACTIVE NOISE CONTROL SYSTEM  U010087  Lost Communication With ECM/PCM "A" Missing Message  U012987  Lost Communication With Brake System Control Module Missing Message  U014087  Lost Communication with Body Control Module Missing Message  U016487  Lost Communication with HVAC Control Module Missing Message  


DESCRIPTION

These DTCs are stored when a malfunction occurs in the CAN communication circuit.

DTC No. Detection Item DTC Detection Condition Trouble Area
U010087 Lost Communication With ECM/PCM "A" Missing Message When the stereo component equalizer assembly detects a CAN communication malfunction in the engine system for 1 second or more continuously 3 seconds after the ignition switch is turned to ON* CAN communication system
U012987 Lost Communication With Brake System Control Module Missing Message When the stereo component equalizer assembly detects a CAN communication malfunction in the brake system for 1 second or more continuously 3 seconds after the ignition switch is turned to ON* CAN communication system
U014087 Lost Communication with Body Control Module Missing Message When the stereo component equalizer assembly detects a CAN communication malfunction in the main body ECU for 3 seconds or more continuously 3 seconds after the ignition switch is turned to ON* CAN communication system
U016487 Lost Communication with HVAC Control Module Missing Message When the stereo component equalizer assembly detects a CAN communication malfunction in the air conditioning system for 25 seconds or more continuously 3 seconds after the ignition switch is turned to ON* CAN communication system

HINT:

*: Malfunction monitoring is not performed under the following conditions, in order to prevent erroneous detection.

·

After ignition switch is turned to ACC for 3 seconds or more.

·

After the auxiliary battery voltage returns to normal for 3 seconds.

·

Before 3 seconds have elapsed after auxiliary battery voltage has returned to normal.



PROCEDURE

1.CLEAR DTC
a.

Clear the DTCs.

Body Electrical > Active Noise Control > Clear DTCs
50002 415

Result:
Proceed to
NEXT



NEXT

2.CHECK FOR DTC
2.CHECK FOR DTC
a.

Check for DTCs.

Body Electrical > Active Noise Control > Trouble Codes
50001 415

Result:
Result Proceed to
DTC U010087, U012987, U014087 and U016487 are not output A
DTC U010087, U012987, U014087 and U016487 are output B


HINT:
·

If CAN communication system malfunction DTCs are output, they may also be output for other systems.

·

If the CAN communication system has been checked and repaired in other systems, the DTC will not be output after rechecking for DTCs.

·

If the DTC is output frequently, duplicate the conditions that cause a malfunction and perform the check again, even though the DTC was not output after rechecking for DTCs.

Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING




A

B