Home › Engine / Hybrid System › G16E-GTS (ENGINE CONTROL) › THROTTLE BODY › from 2020.09
RM36W0E _51 Engine / Hybrid System _095127 G16E-GTS ENGINE CONTROL _0449857 THROTTLE BODY G

G16E-GTS ENGINE CONTROL  THROTTLE BODY  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 22030 1.INSPECT THROTTLE BODY WITH MOTOR ASSEMBLY

a.

Check the idle speed.

i.

Start the engine and check that the MIL is not illuminated. After the engine is warmed up, check that the idle speed is within the specified range with the A/C switch off.

Standard Idle Speed:

950 to 1050 rpm


NOTICE:
·

Be sure to perform this step with all accessories off.

·

Make sure that the shift lever is in P or N.




ii.

Perform a road test and confirm that there are no abnormalities.



b.

Inspect the throttle position sensor.

i.

Connect the GTS to the DLC3.


ii.

Start the engine.


iii.

Turn the GTS on.


iv.

Enter the following menus: Powertrain / Engine / Data List / Throttle Position Sensor No.1 Voltage %.

Powertrain > Engine > Data List
Tester Display
Throttle Position Sensor No.1 Voltage %
50003 372 216

v.

According to the display on the GTS, read the Data List while fully depressing the accelerator pedal and check that the value is 60% or higher.

If the value is less than 60%, check the throttle body with motor assembly, wire harness and ECM.