Home › Engine / Hybrid System › G16E-GTS (ENGINE CONTROL) › ACCELERATOR PEDAL › from 2020.09
RM36W0E _51 Engine / Hybrid System _095127 G16E-GTS ENGINE CONTROL _0449858 ACCELERATOR PEDAL G

G16E-GTS ENGINE CONTROL  ACCELERATOR PEDAL  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 78110K 1.INSPECT ACCELERATOR PEDAL SENSOR ASSEMBLY

a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch on (IG).


c.

Turn the GTS on.


d.

Enter the following menus: Powertrain / Engine / Data List / Accel Position Sensor No. 1 Voltage and Accel Position Sensor No. 2 Voltage.

Powertrain > Engine > Data List
Tester Display
Accelerator Position Sensor No.1 Voltage
Accelerator Position Sensor No.2 Voltage
50003 372 87,88

e.

Read the values displayed on the GTS.

Standard Voltage:
Tester Display Condition Specified Condition
Accelerator Position Sensor No. 1 Voltage Accelerator pedal is fully released 0.5 to 1.1 V
Accelerator pedal is fully depressed 2.6 to 4.5 V
Accelerator Position Sensor No. 2 Voltage Accelerator pedal is fully released 1.2 to 2.0 V
Accelerator pedal is fully depressed 3.4 to 4.75 V


If the result is not as specified, check the accelerator pedal sensor assembly, wire harness and ECM.